Download Sharp AR-FX12 Specifications

[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 42 ページ ２００４年１０月２６日　火曜日　午後３時４４分
SW Bit
No. No.
50
51
7
Item
Setup of send/receive
complete sound
(buzzer length)
8
Not used
1
Voice answering send
level to the line
Switch selection and function
USA
Used to set the buzzer length from the speaker made after completion of FAX
transmission and reception. Excluding when a communication error occurs.
1: 3sec
0
Initial value
Key
operator
1sec
0: 1sec
0
Used to set the voice answering volume to the line. Set to Large or Small with
the hardware.
1: Small
0
Large
0: Large
2-7 Not used
1
0
0
0
0
0
8
Line monitor range
Used to set the line monitor range when the line monitor function is used.
When set to "Until NSF signal send/receive," monitoring is made until DCS or
NSF signal is received. When set to "All," all are monitored until the line is
disconnected.
1: All
52 1,2 Ringing sound volume
Used to set the ringing sound volume in reception regardless of handset
installation.
The sound volume is available in the following four levels.
Bit No.
1
2
0
0
Small
0
1
Medium
1
0
Large
1
1
Used to set the speaker volume in line monitoring.
The volume is available in the following 4 levels.
Bit No.
Sound NO
5,6 Speaker volume when
on-hook (Speaker
volume when DTMF
sending)
Until NSF
signal send/
receive
1
Medium
Initial setup
Medium
Initial setup
Medium
Initial setup
0: Until sending/receiving NSF signal
Sound NO
3,4 Line monitor sound
volume setup
0
1
0
3
4
0
0
Small
0
1
Medium
1
0
Large
1
1
Used to set the speaker volume when the on-hook button is pressed.
The volume is available in the following 3 kinds.
Bit No.
Medium
0
5
6
0
0
Small
0
1
Medium
1
0
Large
1
1
7,8 Not used
1
0
1
0
53 1,2 Transmission end sound Used to set the volume of transmission end sound from the speaker when FAX
volume
transmission is completed. The sound volume is available in the following 4
kinds.
Bit No.
Sound NO
1
2
0
0
Small
0
1
Medium
1
0
Large
1
1
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-42
0
0
Sound NO