Download Mitel Superset 4 User guide

HANDSFREE OPERATION
communicate
in only one direction
at a time. If
both parties talk at once, the unit gives precedence
to the higher volume
sound, so some of the
‘conversation
will be lost. Therefore,
in handsfree
operation,
it is best to wait until the other party
pauses or stops talking before you begin to speak.
Sometimes
when
I use the set in handsfree
voice
cannot
be heard
clearly
by the other
I doing
wrong?
For
best
guidelines:
observe
the
am
following
Direct your voice toward the SUPERSET qTM set.
Otherwise,
your voice may sound “hollow”, far
away or quiet to the listening party.
l
Speak at a reasonable
distance
(an arm’s
length) from the set. If you are farther away or
have a quiet voice, speak a little louder.
l
l
l
Sometimes
operation,
mode,
my
party.
What
Reposition
the set so that other sources of
noise, such as fans, typewriters,
computers,
printers, radios or nearby conversations
do not
compete with your voice.
Do not block the microphone,
located at the
front edge of the set. Remove any obstacles
such as books, pads, or your hand, which may
block the sound, and thus reduce the sound
quality.
I lose
all or part
of an incoming
call.
Why?
If the set is being used handsfree in a noisy room,
all or part of the incoming call may not be heard.
Try to lower the noise level of the room by
reducing competing
sources of noise (fans, radios,
printers, etc.) A sound-absorbing
environment
will
also enhance sound quality. Rooms with bare hard
2-38
Call Handling
Features