Download Dremel 4200 Specifications
Transcript
EZ Lock™ and EZ Drum™ Operating Instructions EZ Lock™ Mandrel No. EZ402 has a spring loaded sleeve and is used with cutting wheels, abrasive buffs and polishing cloth. FIG. 2 FIG. 1 1 2 Always unplug rotary tool before changing accessories. Incorrect seating of wheel on mandrel may lead to personal injury orproperty damage. FIG. 3 ! WARNING 3 To load accessory: 1. Pull EZ Change™ levers down towards unlock sign on the tool (Fig. 1). Place EZ Lock™ mandrel (1) into EZ Change™ chuck (2) as deep as possible (Fig. 2) and release EZ Change™ levers to tighten (Fig. 3). Note: there is a blue spacer (3) on the mandrel that will bottom out on the EZ Change™ chuck, setting the mandrel to the correct depth. 2. Pull spring-loaded sleeve (4) DOWN towards tool with one hand and hold. You can brace the tool on the body or work-bench for extra leverage (Fig. 4). 3. With the other hand, align bowtie shape on cut-off wheel with mandrel and make sure metal insert is facing away from the tool (Fig. 5). 4. Place wheel on the mandrel to a point just below the bowtie on the mandrel and twist 90 degrees until the bowtie shape on the wheel aligns with the sleeve. Release sleeve. Wheel should lock in place (Fig. 6). 5. When mounting sanding and polishing accessories, align bowtie with metal insert on bottom of accessory (Fig. 7a & 7b). To check for proper seating, hold collet lock button and twist accessory. Accessory will not be able to rotate on mandrel. To unload accessory: 1. Pull spring-loaded sleeve DOWN toward tool with one hand (Fig. 4). 2. Hold sleeve down while twisting accessory 90 degrees. 3. Remove accessory. During use Avoid damage to EZ lock™ mandrel by not letting it contact the workpiece. FIG. 4 4 FIG. 5 FIG. 6 90˚ 19