Download HP 3300 User guide
Transcript
Chapter 4 To install the Mac HP All-in-One software Note The following instructions are for Mac computers only. 1. 2. 3. 4. 5. 6. 7. Quit all applications running on your computer. Insert the Mac CD that came with your HP All-in-One into the CD-ROM drive on your computer. Double-click the HP All-in-One installer icon. On the Authentication screen, enter the Administrator password used to access your computer or network. The installer software looks for HP All-in-One devices, and then lists them. On the Select Device screen, select your HP All-in-One. Follow the onscreen instructions to complete all the installation steps, including the Setup Assistant. When you have finished installing the software, your HP All-in-One is ready for service. To test your network connection, go to your computer and print a self-test report to your HP All-in-One. For more information, see Print a self-test report. Connect to additional computers on a network You can connect your HP All-in-One to more than one computer on a small network of computers. If your HP All-in-One is already connected to a computer on a network, for each additional computer you must install the HP All-in-One software, as described in Install the software for a network connection. During installation of a wireless connection, the software will discover the SSID (network name) of the existing network. Once you have set up your HP All-in-One on the network you will not need to configure it again when you add additional computers. Note You can have both a wired or wireless connection and a USB connection to your HP All-in-One. However, you cannot have both a wired and a wireless connection to the same HP All-in-One. Change the HP All-in-One from a USB connection to a network connection Network setup If you first install your HP All-in-One with a USB connection, you can later change to either a wireless or Ethernet network connection. If you already understand how to connect to a network, you can use the general directions below. For more detailed instructions on connecting a HP All-in-One to a network, see Wireless infrastructure network setup, Wireless ad hoc network setup, or Wired network setup. Note For optimal performance and security in your wireless network, use an access point (such as a wireless router) to connect your HP All-in-One. To change a USB connection to a wireless connection 1. Unplug the USB connection from the back of your HP All-in-One. 2. Press Setup on the control panel of your HP All-in-One. 72 HP Photosmart 3300 All-in-One series