Download Siemens XT75 Specifications

s
XT65/XT75 Hardware Interface Description
3.17 Control Signals
3.17.3
Behavior of the RING0 Line (ASC0 Interface only)
The RING0 line is available on the serial interface ASC0 (see also Section 3.10). The signal serves to indicate
incoming calls and other types of URCs (Unsolicited Result Code).
Although not mandatory for use in a host application, it is strongly suggested that you connect the RING0 line to
an interrupt line of your application. In this case, the application can be designed to receive an interrupt when a
falling edge on RING0 occurs. This solution is most effective, particularly, for waking up an application from
power saving. Note that if the RING0 line is not wired, the application would be required to permanently poll the
data and status lines of the serial interface at the expense of a higher current consumption. Therefore, utilizing
the RING0 line provides an option to significantly reduce the overall current consumption of your application.
The behavior of the RING0 line varies with the type of event:
•
When a voice/fax/data call comes in the RING0 line goes low for 1s and high for another 4s. Every 5 seconds
the ring string is generated and sent over the /RXD0 line.
If there is a call in progress and call waiting is activated for a connected handset or handsfree device, the
RING0 line switches to ground in order to generate acoustic signals that indicate the waiting call.
4s
4s
1s
Ring
string
1s
Ring
string
1s
Ring
string
Figure 36: Incoming voice/fax/data call
•
All other types of Unsolicited Result Codes (URCs) also cause the RING0 line to go low, however for 1 second
only.
RING0
1s
URC
Figure 37: URC transmission
3.17.4
PWR_IND Signal
PWR_IND notifies the on/off state of the module. High state of PWR_IND indicates that the module is switched
off. The state of PWR_IND immediately changes to low when IGT is pulled low. For state detection an external
pull-up resistor is required.
XT65_XT75_HD_v01.001
Confidential / Released
Page 72 of 133
2007-1-8