Download Epson C82363 Specifications

Chap3.fm Page 1 Friday, August 21, 1998 11:11 AM
Chapter 3
Setting the IP Address
To use the Ethernet card with TCP/IP, you first need to set its IP
address.
Overview
Follow these general steps to set the card’s IP address. See the
indicated chapters for more information.
1.
Install TCP/IP protocol on the operating systems, if necessary.
See the section below.
2.
For Windows or Macintosh, install EPSON Net!2. See Chapter 2.
3.
Set the IP address using either:
❑
The arp command (see page 3-8)
❑
EPSON Net!2 for Windows/Macintosh (see page 3-10)
Note:
EPSON Net!2 cannot be used for OS/2 or UNIX. When
setting the IP address for OS/2 or UNIX, use the arp command.
4.
Set up the printer. See Chapters 6 through 9.
Installing the TCP/IP Protocols in Your PC
Before using the Ethernet card with TCP/IP, you must make sure that
the TCP/IP protocol is installed on your operating system. After it is
installed, you can use the computer to configure the Ethernet card for
use with TCP/IP.
Setting the IP Address
3-1