Download Wolf DF364C Installation guide

Wolf Dual Fuel Ranges
3
wolfappliance.com/specs
Dual Fuel Range Installation
IMPORTANT NOTE: This installation must be completed
by a qualified installer, service agency or gas supplier.
Wolf Dual Fuel Range
Read this entire installation guide prior to installation and
save for the local inspector’s reference. The homeowner
should keep this installation guide for future reference.
Serial Number
This appliance must be installed in accordance with
National Electrical Codes, as well as all state, municipal
and local codes. The correct voltage, frequency and
amperage must be supplied to the appliance from a dedicated, grounded circuit which is protected by a properly
sized circuit breaker or time delay fuse. The proper
voltage, frequency, and amperage ratings are listed on
the product rating plate.
Wolf dual fuel ranges are manufactured for use with
natural gas or LP gas. Check the product rating plate for
the type of gas for your specific model. If this appliance
does not correspond to your type of gas, contact your
authorized Wolf dealer.
Record the model and serial numbers before installing the
dual fuel range. Both numbers are listed on the product
rating plate, located on the bottom of the control panel
assembly, at the far right, just above the oven door. Refer
to the illustration below.
RATING PLATE
Location of rating plate.
Model Number