Download Canon JX510P User`s guide

6
7
Use the numeric buttons, or [{] or [}] to enter the redial interval, then press [Start/
Copy].
Press [Stop/Reset].
Setting ends and the fax returns to standby mode.
„ Setting <PIN ENTRY>
If you set the <PIN ENTRY> setting to <ON>, you must enter a password to use the forwarding
feature (see page 51).
1
2
3
4
5
Follow steps 1 to 4 in “Setting the Forwarding Number” on page 50.
Use [{] or [}] to select <ON>, then press [Start/Copy]. The LCD displays <FWD
TEL NUMBER>.
Use [{] or [}] to select <PIN ENTRY>, then press [Start/Copy]. The LCD displays
<ON>.
Use [{] or [}] to select <ON>, then press [Start/Copy].
Press [Stop/Reset].
Setting ends and the fax returns to standby mode.
When a Forwarded Call is Received
When <FWD SETTINGS> is set to <ON>, telephone messages recorded when the fax is set to TAM
mode will be automatically forwarded to a registered forwarding number.
1
2
3
A call is received at the forwarding number.
When you answer the phone you will hear your forwarding message.
Press [#] while the forwarding message is playing.
If you have not set a forwarding message, press [#] when you hear the tone.
4
Enter your password when you hear the beeps.
z When <PIN ENTRY> is set to <OFF> (see page 51), step 4 is not required.
z If you enter an invalid password, you will hear an error tone. If you enter two invalid
passwords consecutively, the call will be disconnected.
5
6
7
Any new telephone messages will be played.
When playback ends, it will be possible to use the remote control features.
For the remote control features, see page 47.
Hang up the Handset when you have finished.
Using TAM Mode (JX510P only)
51