Download Curtis 2000 Specifications
Transcript
4 — OEM-SPECIFIED, FACTORY-SET PARAMETERS KEY OFF DECEL The key off decel function decelerates the vehicle to zero speed per the specified deceleration delay if the keyswitch is turned off while the vehicle is in motion. If the key off decel function is disabled, the controller shorts the motor if the keyswitch is turned off, causing a severely abrupt stop of the vehicle. It is therefore recommended that the key off decel function be enabled. Default setting ➤ On OEM specifies ➤ On or Off POWER SAVER The power saver function releases the main contactor if the controller does not receive any throttle commands in a 25-second period; it shuts the controller off completely if no commands are received in a 25-minute period. This reduces the residual current draw on the batteries and extends vehicle range. The keyswitch must be cycled to activate the controller after the power saver has shut it down. If the power saver function is disabled, the controller will remain on as long as the keyswitch input is active. OEM specifies ➤ Enable or Disable Default setting ➤ Enable MULTIMODE™ A key feature of Curtis PMC MultiMode™ controllers is their capability of being configured for optimized performance in two distinctly defined modes. However, should the OEM prefer to offer only a single mode of operation in a given application, the MultiMode™ feature can be disabled. Additionally, each of the seven MultiMode™ parameters can be individually defined as MultiMode™ or single mode. OEM specifies ➤ On or Off Default setting ➤ On Curtis PMC 1223/33, 1225/35, 1227/37 Manual 48