K1 SYSTEM K1 K1-SB Download

Transcript
CONTOUR configuration
This configuration reinforces the system sub-low frequency response and improves either the side or rear LF rejection,
when the K1-SB array is installed beside or behind the K1 array respectively.
K1 and K1-SB in CONTOUR configuration
1.5 <> 2 m
5 <> 7 ft
0.5 <> 1 m
1.5 <> 3 ft
Recommended ratio
1 K1-SB: 2 K1
Enclosure
K1
K1-SB
[PRESET]
[K1]
[K1SB_60]
Frequency range (-10dB )
30Hz – 20kHz
K1 array
with KI-SB array beside
K1 array
with KI-SB array behind
K1 and K1-SB in CONTOUR configuration + SB28
0.5 <> 1 m
1.5 <> 3 ft
1.5 <> 2 m
5 <> 7 ft
Recommended ratio
1 SB28: 1 K1-SB: 2 K1
Enclosure
SB28
K1
K1-SB
K1 array
with KI-SB array beside
and ground-stacked SB28
K1 array
with KI-SB array behind
and ground-stacked SB28
[PRESET]
[SB28_60]
[K1]
[K1SB_60]
Frequency range (-10dB)
25Hz – 20kHz
Delay settings
When combining a line source with subwoofers, delays may have to be added to the presets.
Refer to the LA8 PRESET LIBRARY user manual to obtain the pre-alignment delay values.
Use [SB28_60_C] with an SB28 subwoofer array in cardioid configuration
The cardioid configuration consists in reversing 1 element in an array of 4 subwoofers.
Refer to the SB28 user manual for details about the CARDIOID mode.
K1_UM_EN_3-1
w w w .l-a cous ti cs .c om
7