Transcript
GROW LIGHT PRO USER MANUAL GROW LIGHT SYSTEM INCLUDES: • Preassembled lighted top including (A): 2 pieces of 8 Watt grow lights, 2 pieces of 8 Watt full spectrum lights, 3 linking cables, 8 hanging clips, 2 top brackets and 3 horizontal poles. E A C D B • 2 adjustable brackets (B) • 4 vertical poles with rubber feet (C) • 3 horizontal poles (D) • 1 wire mesh rack (E) • 2 molded covers (F) • 1 power cord • 2 replacement full spectrum lamps F ASSEMBLY INSTRUCTIONS 1. Remove all parts carefully from the box onto a flat surface such as a floor, or table top. The top of your grow light pro is already assembled. Put this aside; this goes on last (A). 1 2 2. Place one of the adjustable side brackets on a flat surface with the holes facing upward (B) and insert the three (shorter) horizontal poles (D) into the holes. Align the holes of the second adjustable side bracket with the poles to connect. Press firmly together to form the adjustable shelf. 3. With the adjustable feet facing down, slide in the four (longer) vertical legs with rubber feet (C), so that the feet rest on the table top just below the adjustable knobs. 3 4 4. Place the top of the grow light system (A) so that the four holes fit onto the four uncovered pole ends. Push the top shelf down gently but firmly to assure that it is properly seated on the poles. Then press securely in place. Place the wire screen (E) on the adjustable shelf. 5. Place 1 of the clear plastic covers (F) on top of the unit. Place the second cover upside down underneath the stand to catch any dripping water from your plants. 5 6 7 6. Adjust the bottom shelf to the desired height or your seedlings, or plants. The grow lights should be approximately 3" above seedlings and/or growing plants. 7. Insert the connector of the power cord into the protruding end of the last fixture and plug in. 8 8. Turn on each light by the switch located on the side of each fixture. 9. Your Grow Light Pro comes with 4 grow light lamps installed for optimum seed starting and plant growth. For displaying flowers we suggest changing out 2 of the 4 grow light lamps with the 2 full spectrum lamps (included). To change lamps, unplug the power cord first. Then remove the lamp diffusers and rock the lamps out of their sockets holding them carefully at the ends. CAUTION: Keep the cover on when watering plants. Do not water from above the lights. Water and electricity do not mix safely. CAUTION: This is NOT a low voltage device. 120 volts of current are active through all four fixtures at all times even if the light of one fixture is off. Treat the fixtures with the same care as you would treat an active electrical outlet. CAUTION: UNPLUG the power cord from the wall before attempting to change lamps, or otherwise adjust the lighting fixtures. Patent Pending ETL Listed Light Fixtures MADE IN CHINA FRONT