Transcript
Ice Shooters Tray INSTRUCTIONS FOR USE Remove lids from each Ice Shooter mould cup. Fill cup ¾ from the top with water or other non -alcoholic beverage. Carefully replace lid on the cup. Place filled mould into a freezer for at least 5 -6 hours. For best results, place on a flat, level surface. Remove Ice Shooter mould from freezer. To remove Ice Shooter from mould: Run room temperature water over the outside of the mould (not inside) to loosen the frozen Ice Shooter. NOTE: Using hot or warm water will melt the Ice Shooters. PRECAUTIONS It is recommended that the Ice Shooter be removed from the freezer and mould just a few minutes before use. To reduce melting, it is best to pour a chilled beverage into the Ice Shooter. Attempting to remove Ice Shooters from mould without applying water to the outside of the cup will cause the ice to crack during removal. SERVICE & IMPORTANT NOTICE: The manufacturer has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice. Epicureanist is a trademark of Epicureanist LLC. All products, features, and services are subject to change without notice. We cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes. ©2012 Epicureanist LLC. All rights reserved. Epicureanist LLC, 16782 Von Karman Ave., Suite 15, Irvine, CA 92606