Download McIntosh C2300 User's Manual
Transcript
2A C2300 Rear Panel Connections MAIN OUTPUTS (Balanced) send signals to a Power Amplifier MAIN OUTPUTS send signals to a Power Amplifier CDR, CD, D/A and DVD INPUTS (Balanced) accept high level program source signals OUTPUTS 1 and 2 (Balanced) send signals to Power Amplifiers and are switched On/Off with the Front Panel Output 1 and 2 Push-Buttons or Remote Control Push-Buttons OUTPUTS 1 and 2 send signals to Power Amplifiers and are switched On/Off with the Front Panel Output 1 and 2 Push-Buttons or Remote Control Push-Buttons SRVR OUT sends signals to the input of a recording device SRVR, CDR, CD, D/A, DVD and TUNER INPUTS accept high level program source signals GND terminals accept a ground wire from a turntable Connect the C2300 power cord to a live AC outlet. Refer to information on the back panel of your C2300 to determine the correct voltage for your unit Main Fuse holder, refer to information on the back panel of your C2300 to determine the correct fuse size and rating MAIN POWER CONTROL Output sends a turn-on signal to a McIntosh Component when the C2300 is turned on POWER CONTROL ACC sends Turn-On signals to McIntosh Source Components when the C2300 is On. OUTPUT 2 and OUTPUT 1 send Turn-On signals to McIntosh Power Amplifier(s) when activated. POWER CONTROLS ACC, OUTPUT 2 and OUTPUT 1 may be re-assigned as TRIGGERS A - C to send Turn-On signals when a desired Input Source is selected McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549 PASSTHRU Power Control Input receives a turn-on signal from a McIntosh Home Theater Controller Part No. 04106100 EXT SENSOR connector permits the connection of a McIntosh IR Sensor for remote operation DATA PORTS send signals to McIntosh Source Components to allow control with the C2300 Remote Control PHONO MM accepts signals from a Moving Magnet Phono Cartridge PHONO MC accepts the low level signals from a Moving Coil Phono Cartridge 2B C2300 Connection Diagram 3 Note: Refer to the C2300 Owner’s Manual page 9 for additional connection information. McIntosh A/V Control Center Connection Legend: Data Cable*Digital Signal Cable Sensor/Keypad Cable RS232 Cable Power Control Cable* Ground Wire Audio Signal Cable AC Power Cords Video Signal Cable Loudspeaker Cable RF Signal Cable * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end. McIntosh Power Amplifier (Left Channel) - Main Room (Partial View) Connect to AC Outlet McIntosh Power Amplifier (Right Channel) - Main Room (Partial View) Connect to AC Outlet McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549