Download Delta Electronics OPEP-33-B4K3R User's Manual

OPEP-33-B4K3R
1.25Gbps Upstream/1.25Gbps Downstream
GE-PON OLT Transceiver
FEATURES
RoHS compliant
IEEE802.3ah Gigabit Ethernet compliant
2x5 pin SFF package with SC pigtail fiber
1310nm Burst Mode 1.25Gbps receiver, and
1490nm Continuous Mode 1.25Gbps
transmitter
Build in Optical Isolator for extreme Return
Loss tolerance
Single +3.3V power supply
LVPECL electrical signal interface
LVTTL Tx Disable input and Rx Signal Detect
output
Laser Class 1 Product which comply with the
requirements of IEC 60825-1 and IEC 60825-2
Description
Application
IEEE 802.3ah 1000BASE-PX20-D
DELTA’s
GE-PON
OLT
transceiver
OPEP-33-B4K3R is designed for Gigabit Ethernet
Passive Optical Network transmission.
GE-PON OLT
Burst Mode Application
The module is contained in a 2x5 SFF
FTTx WDM Broadband Access
package with a 9/125um SC pigtail single mode
fiber.
The module consists 1490nm un-cool DFB
laser, InGaAs/InP APD, Preamplifier and WDM filter
in a high-integrated optical sub-assembly, and it
receives up to 1.25Gbps of burst-mode data at
1310nm, and transmits 1.25Gbps of continuous
OPEP-33-B4K3R data link up to 20km in
9/125um single mode fiber.
data at 1490nm.
1
DELTA ELECTRONICS, INC.
Revision: S0
10/12/2006
www.deltaww.com
OPEP-33-B4K3R
1. Absolute Maximum Ratings
Parameter
Storage Temperature
Storage Ambient Humidity
Power Supply Voltage
Signal Input Voltage
Receiver Damage Threshold
Lead Soldering Temperature
Lead Soldering Time
Symbol
Ts
HA
VCC
Min.
-40
5
-0.3
-0.3
+4
Typ.
TSOLD
tSOLD
Max.
85
95
4
Vcc+0.3
260
10
Unit
ºC
%
V
V
dBm
ºC
sec
Note
2. Recommended Operating Conditions
Parameter
Ambient Operating Temperature
Ambient Humidity
Power Supply Voltage
Power Supply Current
Power Supply Noise Rejection
Symbol
TA
HA
VCC
ICC
Min.
0
5
3.13
1.25
Data Rate
-100ppm
Typ.
3.3
1.25
Transmission Distance
Max.
70
95
3.47
350
100
1.25
+100ppm
Unit
ºC
%
V
mA
mVp-p
Note
Without air flow
Non-condensing
100Hz to 1MHz
Gbps
20
km
Typ.
Max.
+7
+7
+10
1490
1500
0.44
Unit
dBm
dBm
dBm
dB
nm
nm
dB
dBm
ps
ps
dB
dB/Hz
dB
dB
3. Specification of Transmitter
Parameter
Average Launched Power (B.O.L)
Average Launched Power (E.O.L)
Launched power (Peak.)
Extinction Ratio
Center Wavelength
Spectrum Width (-20dB)
Side Mode Suppression Ratio
Transmitter OFF Output Power
Optical Rise/Fall Time
Total Jitter
Optical Return Loss Tolerance
Relative Intensity Noise
Optical Transmitter Reflectance
Transmitter and Dispersion Penalty
Output Eye Mask
{X1,X2,Y1,Y2,Y3}
Symbol
PO
PO
PP
ER
λC
σ
SMSR
POff
tr/tf
tJ
ORLT
RIN15OMA
Min.
+2.5
+2
9
1480
30
-39
260
153
15
-115
-10
TDP
2.3
Compliant with IEEE 802.3ah
{0.22,0.375,0.20,0.20,0.30}
Note
Note (1)
Note (1)
DFB Laser
Note (2)
Note (3)
Note (4)
Note (5)
Note (1). Launched power (avg.) is power coupled into a single mode fiber with master connector.
B.O.L=Before of Life; E.O.L= End of Life
Note (2). The 20dB width for SLM Laser is taken as 6.07 times the RMS width
Note (3). These are unfiltered 20-80% values.
Note (4): Measure at 27-1 NRZ PRBS pattern
2
DELTA ELECTRONICS, INC.
Revision: S0
10/12/2006
www.deltaww.com
OPEP-33-B4K3R
Note (5). Transmitter eye mask definition
1+ Y 3
Normalized Amplitude
1
1- Y1
0.5
Y1
0
- Y2
0
X1
X2
1- X2 1- X1
1
Normalized Time
4. Specification of Receiver
Parameter
Input Optical Wavelength
Receiver Sensitivity
Input Saturation Power (Overload)
Signal Detect -Assert Power
Signal Detect -Deassert Power
Signal Detect Hysteresis
Data Output Rise/Fall time
Receiver Reflectance
Receiver Threshold Setting Time
Guard Time
Dynamic Range
Symbol
λIN
PIN
PSAT
PA
PD
PA-PD
tr/tf
Min.
1260
-6
-44
0.5
TRTS
GT
DR
Typ.
1310
Max.
1360
-26
Unit
nm
dBm
dBm
dBm
dBm
dB
ps
dB
ns
ns
dB
-27
2
6
260
-12
400
128
0
20
-12
Note
APD
Note (1)
Note (2)
Note (3)
Note (4)
7
Note (1). Measured with Light source 1310nm, ER=9dB; BER =<10 @PRBS=2 -1 NRZ
This assurance should be met with asynchronous data flowing out of the optical transmitter of
the system under test. The output data pattern from the transmitter of the system under test is a
repetition of alternate 0/1 pattern as defined for this measurement.
Note (2). When SD deasserted, the data output is Low-level (fixed)
Note (3). These are 20%~80% values.
3
DELTA ELECTRONICS, INC.
Revision: S0
10/12/2006
www.deltaww.com
OPEP-33-B4K3R
Note (4). Burst mode receiver timing characteristic
ONU#1
Dynamic Range
Receiver Optical
ONU#2
Input Signal
Guard Time
Receiver Electrical
ONU#2
ONU#1
Output Signal
BER @ 10
Receiver Threshold Setting Time
− 12
5. Electrical Interface Characteristics
Parameter
Transmitter
Total Supply Current
Differential line input Impedance
Differential Data Input Swing
Data Input Voltage- High
Data Input Voltage- Low
Transmitter Disable Input-High
Transmitter Disable Input-Low
Receiver
Total Supply Current
Differential Data Output Swing
Data Output Voltage-High
Data Output Voltage-Low
Signal Detect Output Voltage-High
Signal Detect Output Voltage-Low
Symbol
Min.
Typ.
ICC
RIN
VDT
VIH-VCC
VIL-VCC
VDISH
VDISL
80
400
-1.165
-1.810
2
0
100
ICC
VDR
VOH-VCC
VOL-VCC
VLOSH
VLOSL
400
-1.085
-1.830
2
0
Max.
Unit
Note
A
120
1600
-0.880
-1.475
Vcc
0.8
mA
Ohm
mVp-p
V
V
V
V
Note (1)
B
1800
-0.880
-1.555
Vcc+0.3
0.8
mA
mVp-p
V
V
V
V
LVPECL
LVTTL
Note (1)
LVPECL
LVTTL
Note (1). A (TX)+ B (RX) = 350mA (Not include termination circuit)
4
DELTA ELECTRONICS, INC.
Revision: S0
10/12/2006
www.deltaww.com
OPEP-33-B4K3R
6. Pin Description
Tx/Rx
Pin No.
1
2
I/O
Rx
3
O
4
5
6
7
O
O
RD(n)
RD(p)
VccT
VeeT
8
I
Tx_Dis
9
10
I
I
TD(p)
TD(n)
MS
Tx
Pin Name
VeeR
VccR
SD
Description
Receiver Ground
+3.3V Receiver Power Supply
Normal Optical Input indicated by logic “High”, and No Optical
Input indicated by logic “Low”.
Inverted Receiver Data Output
Non-Inverted Receiver Data Output
+3.3V Transmitter Power Supply
Transmitter Ground
LVTTL Logic “High” or “Open” to Disable Transmitter, and Enable
Transmitter by Logic “Low”.
Non-Inverted Transmitter Data Input
Inverted Transmitter Data Input
Mounting studs/ connect this pin to Chassis ground
MS
Bottom View
MS
5
DELTA ELECTRONICS, INC.
Revision: S0
10/12/2006
www.deltaww.com
OPEP-33-B4K3R
7. Recommended Interface Circuit
DELTA GEPON OLT Module
1uH
3.3V
10uF
6. VccT
100nF
100nF
1uH
8. Tx_Dis
Tx_Dis
3.3V
82ohm
130ohm
9. TD(p)
Z0=50ohm
Transmitter
100nF
10. TD(n)
Z0=50ohm
100nF
150ohm
150ohm
82ohm
130ohm
7. VeeT
3.3V
Protocol IC
2. VccR
SerDes IC
10uF
3.3V
130ohm
82ohm
Z0=50ohm
Z0=50ohm
130ohm
100nF
5. RD(p)
4. RD(n)
Receiver
82ohm
SD
3.3V
3. SD
1. VeeR
6
DELTA ELECTRONICS, INC.
Revision: S0
10/12/2006
www.deltaww.com
OPEP-33-B4K3R
8. Outline Dimensions
Parameter
Mechanical Dimensions
Connector Type
Minimum Fiber Bending Radius
Maximum Fiber Contact Temperature
Unit
mm
mm
ºC
Description
49.5x13.34x9.6
SC/UPC connector
20
85
Tensile Force on Pigtail
Kg
1
Maximum Fiber Stress Allowance
Fiber length (L)
kpsi
mm
200
540 +/-20
Note
IEC-61754-4
.
J
r
e
t
p
a
h
c
b
u
S
R
F
n
oC
i
t
1
a
2
i
t d,
c
a
s
u
r
d
d
r
a
o Ad
r
Dn
P
Fa
t
rh
s
e
t
s
ie
aw
c
L
n
s
a
em
1l
i
r
s
po
sm
f
a
r
l
oe
C
Cp
W eek (52W eeks/Year) : 1月 2日 =01
7
DELTA ELECTRONICS, INC.
Revision: S0
10/12/2006
www.deltaww.com
OPEP-33-B4K3R
9. Regulatory Compliance
Feature
Electrostatic Discharge
(ESD) to the Electrical
Pins
Test Method
Reference
Performance
Human Body Model MIL-STD-883E Method 3015.7
(HBM)
EIA-JESD22-A114
(1) Satisfied with
Machine Model (MM) EIA-JESD22-A115
Electrostatic Discharge
(ESD) to the Simplex
Receptacle
Contact Discharge
Air Discharge
Radio Frequency
Electromagnetic Field
Immunity
IEC/EN 61000-4-2
IEC/EN 61000-4-3
electrical
characteristics of
product spec.
(2) No physical damage
FCC Part 15 Class B
EN 55022 Class B
Electromagnetic
Interference (EMI)
Laser Eye Safety
IEC/EN 61000-4-2
(CISPR 22A)
FDA/CDRH
FDA 21CFR 1040.10, 1040.11
CDRH File # 0420993
TUV
IEC/EN 60825-1
IEC/EN 60825-2
TUV
Certificate
R50032471
TUV
IEC/EN 60950
UL/CSA
UL 60950
#
Component Recognition
UL File # E239394
Appendix A. Document Revision
Version No.
S0
Date
2006-10-12
Description
Preliminary datasheet
8
DELTA ELECTRONICS, INC.
Revision: S0
10/12/2006
www.deltaww.com