Transcript
SAVONA™ PEDESTAL SINK VITREOUS CHINA SAVONA™ PEDESTAL SINK • Contemporary-styled basin with raised faucet deck and backsplash • Made from vitreous china • Convenient soap/accessory ledge • Rear overflow • Design-matched to Savona toilets • Supplied with mounting kit • Shown with 3801.432 Jasmine Spread Lavatory Faucet with Perfume Bottle Handles (not included) ❏ 0156.803 Faucet holes on 8" (203mm) centers Nominal Dimensions: 635 x 502 x 864mm (25" x 19-3/4" x 34") Separate Components: ❏ 0156.008 Pedestal top-8" (203mm) centers ❏ 733900-400 Pedestal only Bowl sizes: 464mm (18-1/4") wide 324mm (12-3/4") front to back 152mm (6") deep 572mm (22-1/2) FINISHED WALL 203mm (8) 70mm (2-3/4) 140 mm (5-1/2) REF. 216mm (8-1/2) PEDESTAL TO WALL CLEARANCE 502mm (19-3/4) PEDESTAL ANCHORING SCREW HOLES 8mm (5/16) DIA. Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M for Vitreous China Fixtures 241mm (9-1/2) REF. To Be Specified: ❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Fawn Beige ❏ Black ❏ Faucet*: ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap: C/L 203mm (8) 527mm *(20-3/4) FINISHED FLOOR * See faucet section for additional models available FITTING DECK 70mm (2-3/4) 35mm (1-3/8) DRAIN CHASE 197mm (7-3/4) 178mm (7) 635mm (25) 19mm (3/4) DIA. HOLES FOR ANCHOR BOLTS SUPPLIES AS REQUIRED 1-1/4 O.D. WASTE 864mm (34) REF. *584mm (23) OPEN TO FLOOR 1-1/4 O.D. TAILPIECE 178mm (7) NOTES: DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE *SUGGESTED. ▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED. ■ SUITABLE FOR REINFORCEMENT ONLY. ACTUAL DIMENSIONS MUST BE TAKEN FROM FIXTURE. FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY. PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS. INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages © 2008 AS America Inc. J6 Revised 2/08