Download Acura BII32604-34945 User's Manual
Transcript
Accessory INSTALLATION INSTRUCTIONS Application Publications No. BII 32604-34945 ACURA MUSIC LINK™ (FOR iPod® ) PARTS LIST Acura Music Link Adapter (sold separately) P/N 08A28-1H1-800 2007 RDX Issue Date MARCH 2007 Acura Music Link Adapter Kit (sold separately) P/N 08A28-1H2-100 Acura Music Link unit 4 Cushion tapes Bus cable Holder cushion Music Link harness Grommet (Not used) 8 Wire ties 2 Long wire ties CD-ROM (for home computer use only) Quick reference guide Y-Harness Adapter (sold separately) P/N 08A31-0F1-000 Y-harness adapter © 2007 American Honda Motor Co., Inc. - All Rights Reserved. BII 32604-34945 (0703) 08B28-STK-2000-91 1 of 6 3. TOOL AND SUPPLIES REQUIRED #2 Phillips screwdriver Diagonal cutters Ratchet 10 mm Socket Shop towel Open and lower the glove box, disconnect the damper, then push in on the side of glove box to open it past the stoppers. DAMPER Illustration of the Acura Music Link Installed on the Vehicle Push. MUSIC LINK UNIT Push. MUSIC LINK HARNESS GLOVE BOX 6204021B 4. Remove the right center console side trim (four clips). CLIPS (4) BUS CABLE 6206032B INSTALLATION Client Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.” 1. 2. RIGHT CENTER CONSOLE SIDE TRIM Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. 6204030B Disconnect the negative cable from the battery. 5. 2 of 6 BII 32604-34945 (0703) Move the shift lever to the N position. © 2007 American Honda Motor Co., Inc. - All Rights Reserved. 6. Lift up the shift lever trim (six retaining tabs). 8. Open the center console, then remove the beverage holder (six clips). CLIPS (6) BEVERAGE HOLDER SHIFT LEVER TRIM RETAINING TABS (6) 6204050B 7. Remove the left center console side trim (three clips). 6204071B 9. Remove the pocket (two self-tapping screws) and three vehicle connectors. LEFT CENTER CONSOLE SIDE TRIM VEHICLE CONNECTORS CLIPS (3) 6204061B POCKET SELF-TAPPING SCREWS (2) © 2007 American Honda Motor Co., Inc. - All Rights Reserved. BII 32604-34945 (0703) 6204081B 3 of 6 10. To prevent scratching the shift lever and trim, cover them with a shop towel. Routing The Harness 12. Insert the Music Link unit into the holder cushion. HOLDER CUSHION MUSICLINK UNIT SHIFT LEVER SHOP TOWEL Align ends. 6417010B 5426010B 11. Remove the audio unit (four bolts) and disconnect the five vehicle connectors. NOTE: The antenna connector release is on the side of the connector. 13. Connect the bus cable DIN connector (black) and the Music Link harness DIN connector (white) to the Music Link unit. NOTE: To avoid connector damage, orient the connectors properly with the flat side up, and insert them straight in (not crooked.) To remove, pull back on the slide collar to release a locking mechanism. Do not pull on the cable, or you can damage it. AUDIO UNIT MUSIC LINK UNIT MUSIC LINK HARNESS DIN CONNECTOR (white) MUSIC LINK UNIT VEHICLE BOLTS (4) VEHICLE CONNECTORS BUS CABLE DIN CONNECTOR (black) 6204090B 6523010B 4 of 6 BII 32604-34945 (0703) © 2007 American Honda Motor Co., Inc. - All Rights Reserved. 14. Apply a cushion tape around the bus cable DIN connector (black) and Music Link harness DIN connector (white). Secure the Music Link unit to the front side of the vehicle frame using two long wire ties. If the Music Link unit is not in front of the frame there will not be clearance for the radio. 16. Get the Y-harness adapter cable. Connect one end of the bus cable 14-pin connector to the Music Link, and the other vehicle 14-pin connector to the Y-harness adapter connector. VEHICLE 14-PIN CONNECTOR MUSIC LINK HARNESS DIN CONNECTOR (white) BUS CABLE 14-PIN CONNECTOR BUS CABLE DIN CONNECTOR (black) LONG WIRE TIES BUS CABLE 14-PIN CONNECTOR VEHICLE 14-PIN CONNECTOR CUSHION TAPE SIDE VIEW FRONT VEHICLE FRAME VEHICLE FRAME MUSIC LINK UNIT Y-HARNESS ADAPTER CUSHION TAPE Y-HARNESS ADAPTER CONNECTOR MUSIC LINK UNIT 6205043B CUSHION TAPE 6205052B 17. Wrap the two connectors with two cushion tapes. 15. Align the Music Link connector with the right side of the glove box opening. Bundle up the Music Link harness and secure it to the vehicle harness with one wire tie. VEHICLE HARNESS Bundle the excess. WIRE TIE 18. Adjust the length of the Y-harness adapter 14-pin connector to the same length of the radio connector so it aligns with the vehicle 17-pin connector. GLOVE BOX OPENING 6205011B © 2007 American Honda Motor Co., Inc. - All Rights Reserved. BUS CABLE (Bundle the excess.) MUSIC LINK HARNESS BII 32604-34945 (0703) VEHICLE Align. 17-PIN CONNECTOR Y-HARNESS ADAPTER 6205062B 5 of 6 19. Bundle the excess bus cable, and wrap one wire tie around the bus cable. VEHICLE HARNESS WIRE TIE 22. Put the Music Link harness in the glove box as shown and position the glove box to its original position. Reconnect the damper to the glove box. BUS CABLE (Bundle the excess.) DAMPER MUSIC LINK HARNESS GLOVE BOX 23. Check that all wire harnesses are routed properly and all connectors are plugged in. 6206022B WIRE TIE GLOVE BOX OPENING 24. Reinstall the pocket, the beverage holder, the left and right side trims, and the shift lever trim. MUSIC LINK HARNESS 25. Reconnect the negative cable to the battery. 6523020B 20. Secure the bus cable and Music Link harness to the vehicle harness using two wire ties. 21. Place the audio unit in the center dashboard area and plug the Y-harness adapter connector into the audio unit, then reconnect the audio unit connectors. Reinstall the audio unit using the four vehicle bolts. VEHICLE CONNECTORS 26. If equipped, enter the navigation code. 27. Enter the customer's radio anti-theft code, and reset the radio station presets. 28. Reset the clock. 29. Test the seat heaters. 30. Turn the audio unit ON. Check the CDC EJECT, or CD4 EJECT is shown on the audio unit display while in the CD/AUX or DISC/AUX mode (The Music Link is recognized as a accessory CD changer). 31. Give the CD-Rom disc to your customer. This disc is software for use on home computers, and it also contains an owner's manual. AUDIO UNIT 32. Check the operation of the security system according to the security system user's information provided. RADIO BOLT (Reused.) NOTE: When the battery is disconnected, the driver's window AUTO function is disabled. VEHICLE BOLT (Reused.) Y-HARNESS ADAPTER 14-PIN CONNECTOR 6206010B 6 of 6 BII 32604-34945 (0703) • Start the engine. Push down on the driver's window switch until the window is fully open. • Pull up on the driver's window switch to close the window completely, and then hold the switch for 2 seconds or more. • Lower and raise the driver's window to check the operation of the driver's window AUTO function. © 2007 American Honda Motor Co., Inc. - All Rights Reserved.