Download Gamber-Johnson Mounting Interface Plate

INSTALLATION INSTRUCTIONS
Product
Revision
Form #
Rev.B
INST-369
7160-0043 Interface Plate - Panasonic CF30 Port Replicator
7160-0044 Screen Support - Panasonic CF30 Port Replicator
7160-0043 Interface Plate From the bottom side, insert the Interface Plate inside the Panasonic CF-30 Port Replicator
and attach with (8) .25-20 x .50 Button Head Screws.
Attach the Motion Attachment being used to the Interface Plate with (4) .25 Flat Washers and
(4) .25-20 x .50 Button Head Screws
8X .25-20 x .50 Button Head Screws
Interface Plate
4X .25 Flat Washer and .25-20 x .50 Button Head Screws
Motion Attachment
7160-0044 Screen Support With the 7160-0043 Interface Plate installed, remove the two back .25-20 x .50 Button Head
Screws from the right side. Place the Screen Support Assembly against the outside of the
Panasonic CF-30 Port Replicator and attach by reinstalling the (2) .25-20 x .50 Button Head
Screws.
Panasonic CF30 Port Replicator
Screen Support
2X .25-20 x .50 Button Head Screws
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
1 of 2
7160-0044 Screen Support continued -
7160-0044 can be used as the Screen Support for Panasonic CF27, CF28 & CF29 Port
Replicators that use a GJ-PAN-CF27 Interface bracket.
Attach Screen Support to last hole on right side of Panasonic Port Replicator using screw,
washer and nut found in Hardware Bag 7120-0094 before attaching the GJ-PAN-CF27
Interface.
Complete the install by attaching the GJ-PAN-CF27.
Use the mounting screws supplied with the interface, thru remaining mounting hole on the
scre.en support.
Panasonic Port Replicator
CF27, CF28 or CF29
Nut from
Hardware Bag 7120-0094
inside last hole
7160-0044 Screen Support
attach on Right Side
GJ-PAN-CF27
Screw & Washer from
Hardware Bag 7120-0094
on outside
Screws & Washers supplied with
GJ-PAN-CF27
2 of 2