Download ACTi E67 Technical data

10
Parameterizing in-/outputs
Operating Manual
All available parameters can
be entered in the source parameters.
WE KEEP THINGS MOVING
To be able to poll application status signals, the signals must be allocated to an
output (BA, AA, parameter). There is a source parameter for each output in which
the signals available for the particular application can be selected / inscribed.
Source parameters F61 and F62 are used for the binary outputs BA1 and BA2
shown in the diagram. At the same time, the signal is written in a parameter (D200
bit 1 here). This parameter can be read from a fieldbus system.
The indicator parameter (D181 in the diagram) shows the signal state after handling by the application. It is used to check the signal path. The application descriptions specifies for each signal the possible outputs and the related selection
parameters as well as the fieldbus and indicator parameter.
ID 442281.00
42