Download Range Error Codes

B
WFR 2460 Washer Fault Codes
The last 8 fault codes are stored & displayed!
T1: Error (error displays).
The programme can be ended with the “Start / Pause” button. The errors can
be selected with the “Menu” button. Only the errors of the last 8 wash
programmes are stored and displayed.
Sequence:
Time/Operation Display
Note
HINTS: # of errors
reads “0” for faults
which didn’t occur.
Look at # of errors,
not error #, to see if
faults occurred.
Display
Er: 01
Er: 02
>>MENU T1: ERRORS
7- Er : 12
The error frequency is
displayed on the lower line
and the error number on the
right.
Error #
After 105 min.
Er: 09
Uncontrolled motor
acceleration
Motor does not rotate
Motor triac defective
Er: 10
Er: 11
Er: 16
Reversing relay test
not passed
Flow rate sensor
detects low water level
Water inlet time
exceeded
Water inlet time
exceeded
Pumping time
exceeded
Safety level reached
Er: 17
Pressure sensor
Er: 18
Er: 19
Er: 20
Calibration of pressure
sensor not possible
Aqua stop fault
Turbidity sensor
Er: 21
Er: 22
Update
Spin cycle terminated
Er: 23
Foam detected
Er: 12
Hint: Scroll thru all errors to
check if any occurred.
Possible Cause
Remedial action
Door switch not actuated
Close door, check lock
Er: 05
Door open
Door lock cannot be
released
Door lock cannot be
locked
Door actuation
defective
NTC interruption
Er: 06
NTC short-circuit
Er: 07
Unexpected heating
Er: 04
Heating time exceeded
Er: 13
Number of errors
Error
Er: 03
Er: 08
Triac defective / relay
stuck
Cable break / NTC
damaged
Cable short-circuit / NTC
damaged
Temperature increase
without actuation of
heater
Er: 14
Er: 15
Replace controller
Rectify cable short –
circuit / replace NTC
Rectify cable shortcircuit / replace NTC
Start T/P 18 heater test
programme
42
No / incorrect tachogenerator signal
Sensor / line
Water inlet / sensor
W controller after 6
min.
0 level not reached
within 6 min.
Aqua stop actuated
Calibration not
possible
After 15 start-up
attempts
Via analogue sensor
Start T/P18 heater test
programme
Start T/P4 motor test
programme.
Start T/P4 motor test
programme.
Start T/P4 motor test
programme.
Check line
Replace sensor
Start T/P11 sensor
test programme
Start T/P9 controller
test programme
Check pump circuit
Start T/P8 and 9 level
test programme
Check line
Replace sensor
Start T/P8 level test
programme
Eliminate leaks
Start T/P10 sensor
test programme
Start T/P4 motor test
programme
Consult customer
about dosing