Download Model ESM303 User`s Guide

Model ESM303 Test Stand
User’s Guide
2 SETUP AND SAFETY
2.1 Mounting
Place the stand on a clean, flat and level work area free from vibration. It is suggested to mount the stand
to the work bench via four 5/16-18 screws fastened into the underside of the base. Failure to properly
mount the test stand may make it more vulnerable to tipping, especially if a column extension is used,
causing a hazardous situation.
2.2 Mounting the Control Panel
To avoid damage during shipment, the control panel and mounting
bracket are packaged separately. Install the mounting bracket to the
column utilizing two 1/4-20 screws, as shown in the image at left.
Then, install the control panel to the mounting bracket utilizing two
1/4-28 screws, as shown in the image at left.
The viewing angle may be adjusted by loosening the lever,
positioning the control panel, and re-tightening the lever.
2.3 Connections and Outputs
The following connections and outputs are supplied in the lower rear section of the test stand’s column,
as shown in the illustration below:
USB connector
Outputs force only or force and travel data (optional) via USB. Also allows
for PC control (optional). Plug one end of the USB cable into this connector,
and the other end into a PC’s USB port. Refer to the next sub-section for
driver installation information.
Auxiliary limit switch connector
For interfacing an external limit switch, such as an interlock for a machine
guard door. A pin diagram is shown in the next sub-section.
Control panel cable connector
Plug the cable into this connector.
Power switch
Refer to the Connecting Power sub-section for important safety
information.
Power plug receptacle
Plug the power cord in here. Refer to the Connecting Power sub-section
for important safety information.
4