Download Enterprise Manual.book

596 Series Test Configuration
Monitor Zone
Monitor Zone
Double-click the Monitor Zone icon to open the ACS - Circuit Test window. This feature is used to
monitor the point in real time and execute a test or set on an individual circuit. A zone is selected from
the drop-down list and then all points available for that zone are displayed in the monitor point list.
Selecting a point in the list will immediately switch the monitoring to that point.
Figure 14-7: ACS Circuit Test Window
Volume
Click the up or down arrows to adjust the volume of the monitor output. This is an output
physically located on the 590A card and is used to drive a powered speaker that is usually the
speaker located in the rack-mount microphone station.
Level
This meter displays the current signal level for the selected monitor zone.
Zone droplist
This is a list of zones in the system that are available for monitoring. Select a zone from this list
first and a list of available monitor points for that zone is displayed in the point selection list
located in the middle of the window.
Single Circuit radio button
This selects the function that will be performed when the Start button is pressed. Choose Set to
run an individual circuit set for the selected point. Choose Test to run an individual circuit test
for the selected point.
226
Enterprise Software Suite