Download User Manual - Vincent Associates

Line Fuse Replacement
WARNING
AVERTISSEMENT
To avoid injury or death, unplug the line cord from the line
voltage power source before continuing.
Pour éviter les risques de blessures ou de mort, débranchez le
cordon d'alimentation de la source de tension avant de débuter
cette précédure.
1. A small flat-bladed screwdriver or similar tool is needed to complete this procedure.
Please refer to Figure 1.
2. BE SURE THE LINE CORD IS DISCONNECTED FROM THE LINE VOLTAGE
POWER SOURCE. DO NOT CONTINUE WITH THIS PROCEDURE
WITHOUT REMOVING THE LINE CORD FROM THE VCM-D1.
3. Unplug the line cord from the AC module receptacle. Do not proceed without removing
the line cord from the VCM-D1.
4. Position the VCM-D1 unit so that the rear panel is facing you.
5. Using the small flat-bladed screwdriver or similar tool, insert the tool into the cover door
slot, gently pry open cover door.
6. Insert the tool into the fuse holder slot and gently pry out the fuse holder block.
7. Remove defective fuse(s); replace with new fuse(s).
8. Replace fuse holder into housing
9. Close the cover door.
VCM-D1 User Manual
14