Download 7380 Users Guide 942701.vp

8 General Operation
Heat Transfer Fluid
8.1.11.1
Limitations and Disclaimer
The information given in this manual regarding fluids is intended only to be
used as a general guide in choosing a fluid. Though every effort has been made
to provide correct information we cannot guarantee accuracy of data or assure
suitability of a fluid for a particular application. Specifications may change and
sources sometimes offer differing information. Hart Scientific cannot be liable
for any personal injury or damage to equipment, product or facilities resulting
from the use of these fluids. The user of the bath is responsible for collecting
correct information, exercising proper judgment, and insuring safe operation.
Operating near the limits of certain properties such as the flash point or viscosity can compromise safety or performance. Your company’s safety policies regarding flash points, toxicity, and such issues must be considered. You are
responsible for reading the MSDS (material safety data sheets) and acting
accordingly.
8.1.11.2
About the Graph
The fluid graph visually illustrates some of the important qualities of the fluids
shown.
Temperature Range: The temperature scale is shown in degrees Celsius. The
fluids’ general range of application is indicated by the shaded bands. Qualities
including pour point, freeze point, important viscosity points, flash point, boiling point and others may be shown.
Freezing Point: The freezing point of a fluid is an obvious limitation to stirring. As the freezing point is approached high viscosity may also limit
performance.
Pour Point: This represents a handling limit for the fluid.
Viscosity: Points shown are at 50 and 10 centistokes viscosity. When viscosity
is greater than 50 centistokes stirring is very poor and the fluid is unsatisfactory
for bath applications. Optimum stirring generally occurs at 10 centistokes and
below.
Fume Point: A fume hood should be used. This point is very subjective in nature and is impacted by individual tolerance to different fumes and smells, how
well the bath is covered, the surface area of the fluid in the bath, the size and
ventilation of the facility where the bath is located and other conditions. We assume the bath is well covered at this point. This is also subject to company
policy.
Flash Point: The point at which ignition may occur. The point shown may be
either the open or closed cup flash point. Refer to the flash point discussion in
Section 8.1.8.
Boiling Point: At or near the boiling point of the fluid, the temperature stability is difficult to maintain. Fuming or evaporation is excessive. Large amounts
of heater power may be required because of the heat of vaporization.
29