Download Cordless Telephone User Guide - Forward Telecommunications

Ranger.book Page 13 Tuesday, September 9, 2008 8:51 AM
Installing the Handset Battery Pack
To install the battery pack:
1. Remove the battery cover by
pressing the latch and sliding
the cover down and off of the
Handset.
2. Connect the battery pack
connector, observing correct
polarity to the jack inside the
battery compartment, as
shown on the right.
NOTE
- To avoid causing damage to the battery or handset, do not exert any force on
this connection.
- Once you have made a good connection, then insert the battery pack into
the battery compartment.
- Do not pinch the wires.
3. Replace the cover and slide
the it up until it latches into
the Handset.
Ranger Cordless Phone User Guide
13