Download DA-682A Embedded Computer Windows 7 Software Manual

DA-682A Win7 Software
Installing Moxa Software
4. Next, you may register MXview as a Windows service and create a desktop
shortcut.
5. After you have completed the pre-install configuration, click Install to transfer
MXview to disk and wind up the installation.
6. After MXview has installed, you must enter the IP address of the machine on which it is located. This may
be the localhost address, 127.0.0.1, or if you are connecting to MXview over a LAN it will be a remote IP
address. Additionally, you must configure the ports which MXview will use for HTTP and HTTPS
communications. Once the installation is complete, you may choose to restart the computer to get MXview
up and running
7. After rebooting, the MXview shortcut will appear on your desktop (shown at right). Click on
the shortcut to continue on to the next section and begin the MxView setup.
Basic Configuration of MXview
1. Open MXview (see step 7 of the last section, immediately above) and select Start to initialize the MXview
NMS; wait for the System Status notification to change to Running, then click Launch Client.
4-7