Download "user manual"

10. Appendix- Changing the power supply settings
Both the transformer and the ballast must be connected correctly for the local AC voltage and frequency.
The wrong settings can cause poor performance or demage of the moving head.The factory settings are printed
next to the power cord.
If you want to change the power supply settings,follow the instructions:
Front cover
Fastening screws
UE version:
1.Disconnect the fixture from AC power.
2.Remove the front cover by loosening the 4 screws.
3.Move the wire 1 on the transformer connection block to the position according to the desired voltage.
Example:
Transformer
Ballast
4.Put the cover back before applying AC power.
14