Download MVI56E-MCM / MCMXT

Transcript
MVI56E-MCM / MCMXT ♦ ControlLogix Platform
Modbus Communication Module
5.6
Procedures
Setup Guide
Configure the Quantum Processor as a Modbus Slave
The next part of this tutorial is to configure the remote Modbus Slave. For this
example, the Modbus Slave will be a Quantum processor.
The communication port settings for the Modbus Slave must match the Port 1
settings for the Modbus Master. Use the values in the following table to configure
the Quantum processor with Schneider Electric's Concept programming software
(version 2.6 or higher).
Parameter
Value
Node Address
1
Modbus Protocol
RTU
Baud Rate
19200
Parity
None
Data Bits
8
Stop Bits
1
The following illustration shows the MODBUS PORT SETTINGS dialog box in
Concept version 2.6.
ProSoft Technology, Inc.
June 28, 2010
Page 47 of 64