Download User`s Guide

NEC_Mate.fm Page 11 Monday, November 12, 2012 3:39 PM
5
Pull the upper stabilizer stopper forward, remove the stopper from the
chassis prong, slide the stabilizer in the direction of arrow as shown in the
figure, and remove the stabilizer.
8
Slide the roof cover to the front side and lift up and remove the cover
where it stops.
Stopper
Chassis
prong
Stabilizer
Closing the roof cover
Refer to the following procedure when closing the roof cover.
Please be careful not to pinch, strike, or cut your fingers when removing the
stabilizers.
6
Release the other stabilizer stopper as described in step 5, slide the
stabilizer to the right and then remove it.
7
Slide the right and left slide stoppers inward and remove the lock.
Slide stopper
When closing the roof cover, hold the cover tightly to avoid pinching, striking, or
cutting your fingers.
1
Attach the roof cover at about 40 mm above the back side of the machine
and slide the cover to the back side, keeping the roof cover hook and the
hole of the machine close.
Hook
Hole
11