Download PDF

MAINTENANCE AND FUNCTION / TOOLHEADS
Plastic extruder for two materials
(1.75mm) application.
Driven by two independent stepper motor
drivers, uses two heated
nozzles and temperature sensors.
• ALLOWS MULTICOLOR AND MULTIMATERIAL PRINTS
• ALLOW DISSOLVING SUPPORT MATERIAL, PVA IN WATER AND ABS IN ACETONE. THIS ALLOWS COMPLEX PRINTING GEOMETRIES
• THE DUAL EXTRUDER IS FULLY SUPPORTED BY OUR VOXELIZER SOFTWARE, WHICH ENSURES AUTOMATIC PATH GENERATOIN
AND OPTIMISATION.FULLY SUPPORTED BY VOXELIZER SOFTWARE,
AUTOMATIC PATH GENERATION AND OPTIMISATION
To find more information on how to use
DUAL HEAD extruder, navigate to:
DUAL HEAD EXTRUDER
for two materials 1,75mm
http://zmorph3d.com/using-dual-head-extruder/
CAUTION:
After changing extruder always enable it by going to LCD menu, and choosing:
Select Toolhead >> Dual Head
If left motor rotates very slowly, and overheats, please check config lines :
extruder.hotend.steps_per_mm
1150
delta_current
0.5
If values are different, change them manually, save the file and restart the machine.
44