Download GRSIM User`s Manual

Transcript
Cobham Gaisler AB
5
GRSIM User’s Manual
-driver so/dll file symbol
Loads an I/O driver from the given so/dll file, where the given symbol must be a
pointer to a struct grgpio iodriver.
-output-zeroes-data
Sets quirk that a line that drives output will always read 0 for that line in the data
register.
-restricted-output mask
Sets quirk that only the lines for which the corresponding bit in the given mask is
set can drive output. The other lines behaves as if direction is always set to in (even
when the corresponding bit in the in the direction register is set to 1).
2.2.2.5 (GAISLER IRQMP) Multiprocessor Interrupt controller
options
-broadcast
Enables the broadcast functionality.
-amp cnt
Implement the AMP functionality of the IRQMP controller for cnt instances.
-ext nr
Implement the extended irq controller functionality with extended interrupt nr.
-cpubus busid
If the interrupt controller is located on a separate bus, specify the bus busid where
the CPUs are located.
2.2.2.6 (GAISLER L2C) LEON2 Compatibility, UART
-uart device
By default, the UART is connected to stdin/stdout. In Linux, this switch can be
used to connect the uart to another device. E.g. “-uart /dev/ptypc” will connect the
UART to the pseudo device ptypc. (To communicate with ptypc, the user should
connect to /dev/ttypc).
-fast_uart
Run the uart at infinite speed, rather than the default (slow) baud rate.
2.2.2.7 (GAISLER LEON3|4) LEON3|4 CPU
-smpid num
The cpu’s id that will appear in the cpu index field of %asr17.
-nfp
Disables the FPU to emulate system without FP hardware. Any FP instruction will
generate an FP disabled trap.
-dcsize size
Defines the set-size (kbytes) of the LEON dcache. Allowed values are 1 - 64 in
binary steps.
-dlock
Enable data cache line locking. Default is disabled.
-dlsize size
Sets the line size of the data cache (in bytes). Allowed values are 8, 16 or 32.
-dsets sets
Defines the number of sets in the data cache. Allowed values are 1 - 4.
-drepl repl
Sets the replacement algorithm for the data cache. Allowed values are rnd for
random replacement, lru for the least-recently-used replacement algorithm and lrr
for least-recently-replaced replacement algorithm.