Download Before using your air conditioner, please read

Transcript
Troubleshooting Tips
If one of the following faults occur,
stop the air conditioner immediately,
disconnect the power and then
connect it again. If the problem still
exists, disconnect the power and
contact the nearest customer service
center.
OPERATION/RUN
Indicator(s) continue
Trouble flashing.
Fuse blows frequently or
circuit breaker trips
frequently.
Other objects or water fall
into the air conditioner.
The remote controller
won't work or works
abnormally.
If one of the following
codes appear on the
display area :
E0, E1, E2, E3.....or P0,
P1, P2, P3......
Malfunction Cause
Unit does
Fuse or
not start
breaker may
be blown or
tripped.
Battery in
remote
controller
may be dead.
The time you
have set with
timer is
incorrect.
Unit not
Temperature
cooling
setting not
set correctly
Cold air
blowing
from indoor
unit but
room is not
heating or
cooling.
Air filter is
blocked
Doors or
windows are
open
Clean air
filter
Close
doors and
windows
and check
for drafts
Wait 3-5
minutes
and try
again
The 3 minute
delay
protection
has been
activated
If the trouble has not been corrected,
please contact your local dealer. Be sure
to inform them of the detailed
malfunction and unit model.
Notes: Do not attempt to “repair” the
unit yourself. Always consult an
authorized service provider.
Solution
Check fuse
or breaker
Replace
the battery.
Wait or
cancel
timer
setting.
Set temp
correctly.
Refer to
"Using
remote
control"
section.
15