Download FICON Planning and Implementation Guide

Figure 8-61 QoS priority selection for WWN Zoning
3. The name of the zone will be changed to QoSH (for high priority) or QoSL (for low priority)
in front of the given zone name.
4. To activate the QoS zone, click Activate in the zoning window.
5. Compare the settings at the confirmation window, and select OK to activate the zoning
changes.
6. If a second confirmation window appears, read the message, and select Yes.
7. Click OK after the changes are activated.
8. To verify that the zone is active, click the Active Zone Config tab.
8.4.2 Setting up a high integrity fabric
To merge the two Directors, the Switch Connection Control (SCC) Policy must be set up to
form a high integrity fabric. Therefore, you must set the policy to Strict, which will distribute the
policy only to FOS 5.2.0 or later Directors, resulting in a stable and secure fabric. In the SCC
policy, we show how to include the World Wide Node Name (WWNN) of the two Directors in
the fabric.
Note: The FICON configuration wizard automatically configures the security policies
described here, which are required for 2-byte addressing, even if not cascaded. To add a
switch after using the FICON Configuration wizard, use the FICON Merge Wizard.
Chapter 8. Configuring FICON Directors
303