Download VE 570
Transcript
E N G L I S H MOV ING Y OU R PR OD U C T Warning: You need to get off the elliptical bike before moving it. Stand facing the front of the bike, hold the handlebar and pull the bike towards you. Your bike now rests on the castors and you can move it. When you have finished moving it, hold on to it until the back feet are back on the ground. ADJU S TMEN TS 1 1 LEVELLING THE BIKE Warning: You need to get off the elliptical bike before levelling it. In the event that the product becomes unstable during use, turn one of the level correctors until it is stable again. 2 ADJUSTING THE RESISTANCE According to EN definition, this product is a «speed independent product». You can adjust the braking torque not only through the pedalling frequency, but also by choosing the resistance level manually (by turning the torque controller button on non-motorized products, by pressing the up/down buttons on motorized products). Nevertheless, if you keep the same resistance level, the braking torque will increase/decrease as your pedalling frequency increases/decreases. 3 SETTING THE GRADIENT You can set the gradient of your VE 570 by setting the height of the rear leg. There are three preset positions: Low position = 0 degrees You make equal demands on your upper and lower body. Intermediate position = 5 degrees You make more demands on your upper body while also exercising your lower body. High position = 10 degrees. You make great demands on your upper body while also exercising your lower body. To change the gradient of your bike: 1 - Lowering your bike 2 - Stand behind your bike. 3 - To adjust the height, unscrew and pull out the pin on the tube on the rear leg. Set the gradient and reinsert the pin in the rear tube, screwing it back in fully. WARNING : Ensure that you put the button back in place in the tube on the rear leg and screw it back in tightly. Never exceed the maximum height of the rear leg tube. 4 SETTING PEDAL POSITION Pedal position can be set during assembly. There are three setting positions: Forward: Closest to the handlebars Central Rear: Furthest from the handlebars The optimal set position is the central position. However, to meet performance objectives and to best adapt the bike to your body shape, setting the position will optimise your position on your elliptical bike. The forward position is especially suited to people less than 1.75m tall, while the rear position is especially suited to people over 1.85m tall. 20