Download Racediagnostics user manual rev 1_06

Dual Data Display
When in either the “Boost” or “Command” graphs a second plot line can be
added to the graph which displays the command data on the boost graph or the
boost data on the command graph.
To select the second plot, push the joystick in an upwards direction.
To remove the second plot, push the joystick in a downwards direction.
Dyno Plot
This mode allows the user to create a plot similar to those created by a rolling
road or chassis/hub dynamometer.
To use this mode scroll to the “Dyno Plot” button in the Graph Data menu.
This test should only be carried out on a private road. Ensure that the road is
flat and straight. Move off in the car until in 3rd gear, then decelerate until the
revs are below 1500rpm, next the co-driver should push they joystick to the
right. Continue to drive at this low speed for around 2 too 3 seconds as the
liquid initiates communication with the engine management ECU. Once
comms are initiated an initial BHP and Torque value will be displayed on the
screen, once this is displayed, accelerate with a wide open throttle until a
maximum safe speed or engine RPM is reached.
After the run is complete your maximum BHP and Torque will be displayed.
Plotting of the data will cease when the engine rpm reduces unless the rpm is
less than 3000 rpm.
Plotting of the data will continue until the engine revs goes above 3000 rpm.
www.racediagnostics.com
- 12 –
rev1.06
01/08/2008