Download Technical & Warranty Sheet PDF
Transcript
KARTELL BY LAUFEN FREESTANDING BATH 30 130 12 540 440 380 760 700 610 30 780 ø52 1112 1600 1760 30 SPECIFICATIONS Recommended use Domestic, hotel and commercial Materials Solid surface Colour availability White Fixing requirements Silicone to floor Overflow Yes Capacity 320L Capacity to overflow 250L Plug and waste Overflow waste included Weight 127kg To see the complete Kartel by Laufen range go to www.reece.com.au/bathrooms CLEANING RECOMMENDATIONS We recommend the use of soapy water or approved cleaners.This product should not be cleaned with abrasive materials. Damage caused by any improper treatment is not covered by the product warranty refer to Warranty Conditions on the last page. Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors. Tech Page Version 1 KARTELL BY LAUFEN FREESTANDING BATH SOLID SURFACE CARE INSTRUCTIONS Everyday clearing of the Graphyd® products Renew of To keep Graphyd® products clean please follow some simple rules. The best method to remove stains from soap and water which can appear during everyday use is to wipe up spills as they occur. Just use a soft damp cloth (i.e. cotton). To remove stains which need more attention use the cleaning cream milk or the detergents dedicated to day-to-day cleaning of bathroom. Scratches The removal of the limescale and of the rust should be done by the soft damp cloth and the detergent for those kind of stain. After the product clearing rinse all areas thoroughly with hot water removing the detergent from all surfaces. We recommend to towel whole product to keep Grapyd In perfect condition. It is recommended to protect the surface of the product with the additional coating before first use of composite material products. Resistant stains All strong stains caused by e.g. cosmetics, coffee, wine, cigarette ash or detergents should be removed immediatelly by taking out the substance excess with a soft cloth. Then apply a cleaning method, as in the case of daily care. If the stain is not removed we can use slightly abrasive preparations (Cif, cream milk). The cream milk should be applied on the stain with a soft, damp cloth. It’s necessary to remove the stain by circular movements. For stronger dirt we can use fine-grained sandpaper. Don’t risk it, use a licensed plumber.™ General r KARTELL BY LAUFEN FREESTANDING BATH Renew of the surface finishing If after clean up of the stain, the place will change texture ( will become matt), you can restore the original look of the surface by polishing it with a ppear damp milk or damp damp, soft cloth and the detergent (cream milk). After cleaning, always remove the leftover of the cleaner using a large quantity of hot water. To prevent the stains of water dry the product. Scratches removal – product renew One of the Graphyd® advantages is the renew possibility. The homogenieous structure of this material allows to renew and to bring a moving uct to itional primary apperance of product eben after several years. The repair is made by the Roca Network Service. Please contact our call center 801 88 76 22 to find the closer serviceman. General remarks - Graphyd® specification Any material, incorrectly maintained may be damaged. The most common problems and the possibility of losing warranty benefits may be caused by: the use of harsh chemicals (e.g. acetone, solvents-based measures, measures to drain sewage system, etc.), contact of the product with chemicals, boiling liquids and hot ash or excess are. objects, mechanical damage, and in particular the impact or scratch. Dark colors are less resistant for scratches Day-to-day wear. It’s a standard characteristic of all solid surface materials.. , cream oth. It’s we can Don’t risk it, use a licensed plumber.™ KARTELL BY LAUFEN FREESTANDING BATH Bathtub Kartell by Laufen 176 x 76 Art.-No. 2.2233.2 170 No. 2.2333.2 . EN This instruction must be given to the user. Guarantee/Liability only when assembled by an approved specialist in accordance with the instructions and local regulations. EN General installation instructions EN User manual Protection from damage Instructions for use These instructions for use must be carefully read before installation. Check on content of delivery and condition of the components Check delivery after receipt for completeness and possibly damage (see parts list on page 7). Inform the dealer immediately when damage is apparent. We are not liable for damage arising during or after installation/ fitting. Check door width before starting work Does the bath pass trough the door of the room in which the bath will be installed? Required minimum door width: See dimensions page 5- 6. Lifting/moving The bath must only be lifted/moved using the transport straps provided - never use the hoses or installation parts. Laying circuits Do not lay any circuits under the bath. Use suitable protective covers to prevent damage to surfaces and blockages by dirt or dust arising during fitting. Cover sensitive components (drain, nozzles, control panel) temporarily with a protective cover before starting the installation/fitting. Special precautions When cleaning the tiles, make sure that no ammoniac or a similar aggressive cleaning agent come into contact with the installed parts. Water connection through the water massage or overflow. This connection must absolutely be effected by a qualified specialist. Feed rate: Maximum 20 litres/min (EN 200) Overflow rate: Minimum 36 litres/min (EN 274) Drainage rate: Minimum 48 litres/min (EN 274) Checking that the tub is waterproof After connecting the water supply and drainage pipes, the tub must be filled and examined to ensure that it is waterproof. Changes allowed: Laufen reserves the right to make changes or modifications on any of its products without notice. Don’t risk it, use a licensed plumber.™ 170 x No. 2.2433.2 KARTELL BY LAUFEN FREESTANDING BATH 90 Dimensions mm Art.-No. 2.2233.2 130 1112 1600 1760 12 30 Art.-No. 2.2433.2 Don’t risk it, use a licensed plumber.™ 440 540 380 ø52 480 610 700 30 760 30 780 430 KARTELL BY LAUFEN FREESTANDING BATH EN Tub assembly installation instructions EN Parts list 176 x 76 Art.-No. 2.2233.2 170 x Option 627 Art.-No.: 2.9473.9.000.000.1 Art.-No.: 2.9033.3.000.000.1 10x Art.-No.: 2.9033.4.000.000.1 4x Art.-No.: 2.9033.6.000.000.1 Art.-No.: 2.9033.8.000.000.1 Art.-No.: 2.9980.0.000.000.1 Art.-No.: 2.9443.9.000.000.1 Art.-No.: 2.9433.9.000.000.1 DN40 DN50 Art.-No.: 2.9504.7.000.000.1 Art.-No. 2.2233.2 01 02 b) a) 90 EN Don’t risk it, use a licensed plumber.™ KARTELL BY LAUFEN FREESTANDING BATH 03 04 05 ? a) 4x Ø8 a) ? 4x b) b) ? ? 06 a) 07 08 30 a) b) 09 b) b) 10 a) b) EN Don’t risk it, use a licensed plumber.™ 4x KARTELL BY LAUFEN FREESTANDING BATH 11 12 Siphon trap not included 13 a) b) 14 15 1x 16 17 min. 10 Service EN Don’t risk it, use a licensed plumber.™ 18 KARTELL BY LAUFEN FREESTANDING BATH Service 01 02 25 EN General Information, Maintenance Instructions EN General comments on operation and use For your safety bathtub temperature should not exceed 40°C. Let water out after each bath. Never leave children in the tub unsupervised. Use Beware! Increased risk of slipping when surface is wet. This is particularly so when using soap, shampoo, bath oil, etc. Maintenance instructions The surface is simple to clean and maintain. The smooth surface hardly collects dirt. Regular care: Sponge, soft cloth, somewhat antistatic cleaning agent. The tub will thus retain its gloss and reject dirt. To clean your massage tub, please use a soft sponge, liquid soap and water. Rub dry with a dry cloth. Avoid the use of abrasives or solvents which damage the surface of the tub. After long contact periods, several substances like ink, cosmetics and dyes may leave colouring stains. Lit cigarettes can leave burning rings. These stains and spots a swell as scratches or other small damages can be removed following the recommodations below: Remove heavy dirt with liquid household cleaner e.g. dishwash detergents or liquid soap (observe dilution instructions). Remove lime marks with a decalcifier. Always rinse with plenty of clean water. Give a final polish with a soft cloth. Use no acid cleaning agents or cleaning vinegar. EN Don’t risk it, use a licensed plumber.™ Damage Scratched surfaces should always be treated by a specialist. Serious damages can be repaired with the maintenance kit (2.9996.4.000.000.1). Mix filler and catalyst to a complete dispersion of liquid substance. Apply the filler on the damaged part and let it cure for at least 12 hours at minimum 15°C. Rub the cured filler with a 220 grain glass-paper and also the part around to eliminate any non-homogeneous parts. Clean the surface as described above. Damage resulting from inappropriate treatment by the user will not be covered by our guarantee. KARTELL BY LAUFEN FREESTANDING BATH YEAR IT Y E AL TE QU 15 G UARA N REECE PRODUCT QUALITY GUARANTEE You have purchased a quality product from Reece Pty Ltd ABN 84 004 097 090 (“Reece”). This product is covered by a 15 year replacement product warranty and a 12 month warranty over spare parts and labour. This warranty does not include faults caused by: 15 YEAR WARRANTY – DOMESTIC USE This warranty covers faults in the product construction, material and assembly. Products which are within 15 years from the date of purchase, found upon inspection by an authorised Reece representative, to be defective in construction, material or assembly, will be repaired or exchanged with an equivalent product free of charge. Replaced items become Reece’s property. • Installation or part installation by the purchaser or any person other than a LICENSED PLUMBER All replacement products will be available for collection without charge to the customer at the nearest Reece branch to the customer’s location, or elsewhere as agreed between the customer and Reece. Labour and Spare Parts The labour for the replacement of products and spare parts to which this warranty applies will be supplied by Reece or relevant supplier using licensed plumbers engaged by Reece or relevant supplier within 1 year from the date of purchase. Spare parts which are within 1 year from the date of purchase found upon inspection by an authorised Reece representative to be defective in construction, material or assembly, will be replaced free of charge. Warranty Conditions This warranty will apply only under all of the following conditions: • The item has been installed by a licensed plumber • The item has been installed for and subjected to domestic residential use only • Failure is due to a fault in the manufacture of the product • Proof of purchase (including the date of purchase) is provided • The installation of the product is in accordance with the instructions provided This warranty does not cover products purchased as an ex-display without being fully checked and tested for sale by the manufacturer. • Unsuitable or improper use • Incorrect installation or installation not in accordance with the instructions provided • Normal wear and tear • Inadequate or complete lack of maintenance • Chemical, electrochemical or electrical influences • Harsh detergents or abrasive cleaners used on product finishes 1 YEAR WARRANTY – COMMERCIAL USE ‘Commercial’ use is all use other than for normal domestic residential purposes, including use in non-business places as in public buildings, schools, sports centres and in establishments that contain private bathrooms with high frequency of use by many individuals, such as hotels, motels, retirement villages and hospitals. The Commercial warranty covers this product against manufacturing faults in the construction, material and assembly of both the finished products and any spare parts for a period of 1 year from the date of purchase. Products and spare parts which are found upon inspection by an authorised Reece representative to be defective in construction, material or assembly will be repaired or exchanged free of charge. Replaced items become Reece’s property. The labour for the replacement of products and spare parts to which this warranty applies will be supplied by Reece or relevant supplier using licensed plumbers engaged by Reece or relevant supplier. The Warranty Conditions and exclusions which apply to the domestic use warranty also apply to this commercial warranty. EXCLUSIONS To the fullest extent permitted by law, Reece excludes all liability for damage or injury to any person, damage to any property, and any indirect consequential or other loss or damage. CLAIM PROCEDURE For all warranty queries customers are to contact the branch where the product was purchased. These details can be found on your purchase invoice. BATH.T2.15YR Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Don’t risk it, use a licensed plumber.™