1
Download 81-0357-01
Transcript
PCR Workstations and Cabinets 2. Page 6 Loosen the two screws on the Base Assembly, as shown: NOTE: It is advised to use the remaining bubble wrap to protect the antibacterial-coated surfaces during assembly. 3. Attach the Outer Back Panel to the Base Assembly with two screws, as shown below. Leave the screws loose (do not fully tighten at this time). Outer Back Panel. Note the notch in the top of the panel allows room for the wires. Screw Screw Base 81-0357-01 Rev A
