Download System & Requirements
Transcript
RC-I User Manual System & Requirements Cameras (or dedicated input/output boxes) for which you are missing a license will not send data to the surveillance system. Cameras added after all available licenses are used are unavailable. Getting Additional Licenses Want to add—or have already added—more device channels than you currently have licenses for? In that case, you must buy additional licenses before the cameras will be able to send data to your RC-I system. To get additional licenses for your RC-I system, contact your integrator or dealer. When your license file (.lic) is updated, you can activate your licenses. See Activate Licenses for more information on activating. ADMINISTRATOR RIGHTS When you install RC-I, it is important that you have administrator rights on the computer that should run RCI. If you only have standard user rights, you will not be able to configure the surveillance system. Consult your IT system administrator if in doubt about your rights. IMPORTANT PORT NUMBERS RC-I uses particular ports when communicating with other computers, cameras, etc. What is a port? A port is a logical endpoint for data traffic. Networks use different ports for different types of data traffic. Therefore it is sometimes, but not always, necessary to specify which port to use for particular data communication. Most ports are used automatically based on the types of data included in the communication. On TCP/IP networks, port numbers range from 0 to 65536, but only ports 0 to 1024 are reserved for particular purposes. For example, port 80 is used for HTTP traffic when viewing web pages. When using RC-I, make sure that the following ports are open for data traffic on your network: Port 20 and 21 (inbound and outbound): Used for FTP traffic. FTP (File Transfer Protocol) is a standard for exchanging files across networks. FTP uses the TCP/IP standards for data transfer, and is often used for uploading or downloading files to and from servers. Port 25 (inbound and outbound): Used for SMTP traffic. SMTP (Simple Mail Transfer Protocol) is a standard for sending e-mail messages between servers. This port should be open since, depending on configuration, some cameras may send images to the surveillance system server via e-mail. Port 80 (inbound and outbound): Used for HTTP traffic between the surveillance server and cameras, Ocularis Client, and the default communication port for the surveillance system's Image Server service. HTTP (HyperText Transfer Protocol) is a standard for exchanging files across networks; widely used for formatting and transmission of data on the world wide web. Port 554 (inbound and outbound): Used for RSTP traffic in connection with H.264 video streaming. Port 1024 and above (outbound only): Used for HTTP traffic between cameras and the surveillance server. Port 1234 (inbound and outbound): Used for event handling. Port 1237 (inbound and outbound): Used for communication with the NetCentral add-on product (if used by your organization). Port 22331 (inbound and outbound): Used for communication with the Event Server. Any other port numbers you may have selected to use, for example if you have changed the server access port from its default port number (80) to another port number. Consult the administrator of your organization's firewall if in doubt about how to open ports for traffic. On-Net Surveillance Systems, Inc. 3