Download User`s Manual - Azbil Corporation

Chapter 1. OVERVIEW
● Switch layout and function
Upper peg
Top
Faceplate sheet
Lower peg
14
14
13
13
12
12
SHUTTER
(G)
UV SENSOR
(F) 11
11
10
10
0-5V
The AUR350C has a station address switch and reset switch for communications.
These switches are located behind the faceplate of the AUR350C display area.
When setting a station address or resetting events, pull the upper portion of the
faceplate toward you in order to remove it from the upper peg, and then slide the
faceplate upward.
Switch layout
S2: Reset selection switch. This
DIP switch is used to select a
reset type.
S3: Reset switch. This switch is used
in combination with the reset
selection switch (S2) to clear the
current frequency value to 0 and also
to reset an event upon event
occurrence. The switch initializes the
contents selected from the table
below. When all S2 DIP switches are
OFF, S3 resets an event.
S1: Rotary switch for station
address. The RS-485
communication address switch
is selectable from 0 to F (15).
This switch is always valid after
power ON. If the station address
is set at 0, communication is not
possible.
Loader jack
RS-485 communications
S2 operation
4
Setting
Description
1
When the reset switch (S3) is turned ON, the current value of
inspection frequency 1 is reset to 0.
2
When the reset switch (S3) is turned ON, the current value of
inspection frequency 2 is reset to 0.
3
When the reset switch (S3) is turned ON, the current value of
inspection frequency 3 is reset to 0.
4
When the reset switch (S3) is turned ON, the current value of
inspection frequency 4 is reset to 0.