Download Installer manual

Transcript
F2026 docked with VVM 300 (floating condensing)
-EB15
-EB15-BT1
-EB101
-FL10
-EB101
-QM41
-HQ1 -QM40
-QM1
)
990 NOTE
When cable routing, sensor cables and communication cables must be separated (min 20 cm)
from high voltage cables to prevent interference.
NOTE
Check that you have a VVM 300 with version
1.30 or newer. If you have an earlier model of
VVM 300 the control card must be replaced in
the indoor module. The modular cable is then
connected directly to the outdoor module control card.
F2026 (slave) can be connected to VVM 300 (master).
F2026 is then controlled by VVM 300 and works with
floating condensing to the heating system and prioritises
hot water charging in VVM 300.
If F2026 cannot meet the heating requirement, additional
heat is shunted in from VVM 300. If the ambient temperature drops below the set stop temperature, VVM 300
engages and takes over heating.
16
Chapter 4 | Pipe connections
NIBE™ F2026