Download TRDS4002

TRDS4002
searches the communication parameters of the serial port. It may in any event always
be entered manually.
- Serial Port
Choice of the communication port: COM1, COM2, COM3 or COM4.
- Baudrate
Choice of the transmission speed. It must be set according to all set on the
dipswitches of the coder.
It may assume the following values: 2400, 4800, 9600 or 19200
- Parity
Choice of the parity, which may take on the following values: none, even or odd
- Stop Bit
This parameter may not be altered. It is used to display the status of the "Stop Bit".
For connections in downlink from satellite mode, a baud rate of 9600 must be set
unless requested otherwise in the technical specifications of the satellite downlink..
Once the communication parameters have been set, communication must be enabled
with the coder, by sending it an address (default setting=?????).
Press the Connection push button to gain access to the code send and change
menu, together with a set of push buttons used to send or read certain categories
without entering the appropriate window.
User Manual
Rev. 1.0 - 03/08/05
17 /42