Download DMM-220 User Guide
Transcript
DMM 220 User Guide V1.1 Decoder Status AV Status Video: Status of Decoder output Audio: Status of Decoder output Service CVBS or HDMI Service Type: Service Name from BAT Provider Name: Provider Name from SDT PMT PID: PMT PID Service Name: Service Name from SDT Service ID: Service ID from SDT PCR PID: PCR PID Video Information CVBS or HDMI Video PID: Video PID from PMT Video Standard: Resolution Stream Type: Stream Type MPEG or H264 Aspect Ratio: Aspect Ratio 16:9 or 4:3 Audio Information Audio PID: Audio PID from PMT Audio Sample Rate: Audio Sample Rate 3.2 Audio Format: Audio Format MPEG or AAC Tuner QPSK Setting LNB Freq. (MHz): SatFreq. (MHz): Symbol rate (kBaud): LNB Voltage: LNB 22kHz: DiSEqC: LNB Local Oscillator Frequency Satellite down link frequency Set Symbol rate Select from OFF/13V/18V Select from OFF/22K Select from DiSEqC Off, Port A, Port B, Port C, Port D Configure the satellite settings according to your transponder. Here some helpful hints: - When receiving high band signals (11,8 – 12, 75 GHz) switch LNB 22 kHz on and LNB Freq 10600 - When receiving low band signals (10, 7 – 11, 75 GHz) switch LNB 22 kHz off and LNB Freq 9750 - When receiving vertical signals the LNB Voltage level is 13 Volt - When receiving horizontal signals the LNB Voltage level is 18 Volt 12