Download Configuring the 3512
Transcript
*RESTORAL *RESTORAL Note 1: When Method=Integral Man and Auto are the available selections; When ACTIVATE RESTORAL Method=A/B, Off, Man, Auto, and DTR are the available selections. Initiate? Note 2: Ext P2 St only displays when Method=A/B; Loopback only displays when Method=Integral. Note 3: When Method=Integral, restoral rates of 9.6 (default), 12.0, and 14.4 kbps are Terminate? RESTORAL METHOD DIAL PARAMETER INIT PARAMETERS available. For A/B, all restoral rates indicated are available. Method =Integral :A/B DDS to Dial =Man (Integral) =Off (A/B) :Off :Auto :Man :DTR (See Note 1) DDS Alarms =Off :On From DDS =15 sec :60 sec Dial to DDS =Man :Auto Idles =Off :On Link Down =Off :On AUTO ANSWER Answer =Disable :Enable Cond Ans =Disable :Enable RESTORAL CONFIG DTE =Normal :Muxed Timing =Internal :Ext. P1: Ext. P4 :Ext. P2 Ext. P2 St :Ext. P3: Loopback :Network (See Note 2) MODEM CONFIG Call Progress =0 :1 :2 :3 DIGITAL CONFIG Call Ctrl =SW56 :DDS PHONE NUMBER Dial From # =1 :2-4 DL MONITOR Interval =Disable :Hour :Day Figure 4-5. Dial =Tone :Pulse :Auto View Phone # =1 :2-4 Telco Loops =Off :On Rest Rate =9.6 :2.4 :19.2 :4.8 :24.0 :12.0 :28.8 :14.4 :56.0 :64.0 (See Note 3) Dial Wait =2 sec :4 sec :6 sec Echo Can =Enable Disable To DDS =2 min :4 min Pause Dly =3 sec :6 sec :9 sec :12 sec Pause Dly =3 sec :9 sec :6 sec :12 sec Enter Phone # =1 :2-4 = (Term Char) [:dial string < 50 ASCII characters] Trm Tmr =Off :1 Hr :2 Hrs :4 Hrs DTR =High :Tail :108.1 :108.2 Rest Type =Analog :Dig Mux Loss =Off :On CHn Rate =1.2 (Ch 1 only) =0.0 (Ch 2-8) :1.2 :7.2 :14.4 :2.4 :9.6 :16.8 :4.8 :12.0 :19.2 Telco Jack =Perm :Prog PSTN =On :Off Hold Dialine =Off :3 min :1 min :4 min :2 min :5 min Link Phone # =1 :0-4 Link #n to #0 Link #n to #1 Link #n to #2 Link #n to #3 Link #n to #4 :21.6 :24.0 :28.8 :32.0 :38.4 :48.0 A/B Only =Disable =Enable HoldDialine =Off :1 min:4 min :2 min:5 min :3 min Retrain =High :Low :Off Ans TmOut :15 sec :60 sec =30 sec :90 sec Auto Redial =Off :1-8 *RESTORAL Categories and Parameters Configuring the 3512 4-41