Download User Manual

37
3.2.6. PTZ
Check the below items for proper P/T/Z operation.




Check if the protocol of the connected PTZ camera is correct.
Check if the communication setting including baud rate of the connected PTZ camera is in
accordance with the assigned value for that P/T/Z protocol.
Check if the address of the connected PTZ camera is correct.
Check if wiring to P/T/Z controllers is correct.
Procedure
How to setup PTZ camera with Pelco-D protocol (example)
1) Make sure of serial communication with the PTZ camera through RS-485 port.
2) Select “Pelco-D” in the protocol list, and set address & baud rate.
3) Click “Save” button to confirm this configuration.
PROTOCOL
Select the proper protocol of the connected PTZ camera.
BAUD RATE
User can select the baud rate level from 2,400bps up to 57,600bps.
ADDRESS
Set the P/T/Z driver address of the connected camera.
CONTROL
When the SET button is clicked, OSD menu of the PTZ camera will be shown on the monitor. User
can set the PTZ such as speed, preset, tour, autopan and so on.
PRESET
The system supports the number of preset from 1 to 255.
But it can be restricted by the number that PTZ camera supports.