Download Installation manual

FAN SPLITTER HUB
To the Power supply unit
Fan splitter hub
All the elements that need electricity to run are connected to the
fan splitter hub, located on the bac k of the unit.
This fan splitter hub contains three 4-pin PWM Fan
headers for three fans and one pump.
Pump
Fan 3
(Predator 360 only)
Fan 2
Fan 1
A two-pin header is used to connect Predator unit to motherboard CPU Fan header in order to allow for speed regulation
of fans and pump. 2-pin PCI-express miniFIT power header is
used to provide power to Predator unit.
General characteristics:
- 3x 4-pin PWM fan header (Molex KK 254 standard)
- 1x 4-pin PWM pump header (Molex KK 254 standard)
- 1x 2-pin tacho/PWM header (Molex KK 254 standard)
- 1x 2-pin power header (Molex miniFIT standard)
- 1x Power LED indicator diode (red)
- Rectified PWM input
- Uniform PWM control on all headers
RPM (tacho) and
PWM header
Pump
header
Fan 1/2/3 header
Power
LED light
Unit main power
header
Connecting the pump directly to motherboard
fan header (OPTIONAL)
If you want to control the speed of the pump and the fans separately you should follow the steps below:
STEP 1.:
Disconnect the pump’s cable from the fan splitter hub. You will
need to remove cable ties in order to do so.
STEP 2.:
Connect the pump’s connector to the CPU fan header (preferably) on the motherboard.
/ 26 /
STEP 1
STEP 2