Download MT400A User Manual 11

4.
Recalibrate Motion Controller:
Turn calibration knob fully clockwise.
Start monitored equipment to operating speed WITHOUT LOAD.
Percent meter should go above 100%.
Slowly turn calibration knob counter-clockwise until percent meter reads 100%.
5.
Verify equipment under load
Reconfirm Field Test RPM: ___________ under full load capacity.
6.
MT400 Motion sensor is now ready for normal operation.
NOTE: IF ANY STEP IN THIS TEST PROCEDURE DOES NOT OCCUR AS NOTED,
PLEASE CONTACT MAXI-TRONIC AT 800-659-8250.
Date:
_________________________________
Facility Name:
_________________________________
Location:
_________________________________
Leg Name:
_________________________________
Installer:
_________________________________
Tested by:
_________________________________
To register this MT Motion Controller for warranty please fax a copy of this
completed checklist to Maxi-Tronic, Inc. at 513-398-2536.
Complete one checklist for each MT400 Controller.
21