Download Project Manual 2

Transcript
Project #216
Motor & Lamp
by Sound
OBJECTIVE: To control a motor using light.
Turn the slide switch (S1) on, the motor (M1) spins and the lamp (L2)
lights. As you move your hand over the photoresistor (RP), the motor
slows. Now place finger onto the photoresistor to block the light. The
motor slows down. In a few seconds, the motor speeds up again.
!
Project #217
WARNING: Moving parts. Do not touch the fan or
motor during operation.
Fading Siren
OBJECTIVE: To produce sound of
a siren driving away into the
distance.
Project #218
Fast Fade
Siren
Press the press switch (S2), the
alarm IC (U2) should make the sound
of an up-down siren that gets weaker
with time. The fading is produced by
the charging of the 470mF capacitor
(C5). After it is charged the current
stops and the sound is very weak.
OBJECTIVE:
To produce
sound of a siren driving away
into the distance.
To repeat this effect you must release
the press switch, remove the
capacitor, and discharge it by placing
it across the snaps on the bottom bar
marked A & B. Then, replace the
capacitor and press the switch again.
Replace the 470mF capacitor
(C5) with the 100mF capacitor
(C4), the siren fades faster.
-40-