Download operation

MAINTENANCE
CAUTION
ANY REPAIR WORK MUST BE CARRIED OUT WITH THE MACHINE AT REST AND
DISCONNECTED FROM THE TRACTOR.
CAUTION
DO NOT CARRY OUT WELDING WITHOUT AUTHORIZATION AND INSTRUCTION
FROM THE MANUFACTURER.
CAUTION
DISCONNECT THE MACHINE FROM THE TRACTOR BEFORE ANY WELDING WORK.
DAMAGE TO BATTERY COULD RESULT.
DANGER
ALWAYS USE A PROTECTIVE MASK, GOGGLES AND GLOVES WHEN WELDING,
SANDING OR GRINDING OR WHEN USING A HAMMER OR DRILL.
ALWAYS WORK ON THE MACHINE OUT OF DOORS. IF YOU HAVE TO OPERATE THE
MACHINE WHEN CONNECTED TO THE TRACTOR IN AN ENCLOSED AREA (WHEN
DANGER TESTING AFTER REPAIR OR MAINTENANCE), ENSURE THAT THERE IS SUFFICIENT
VENTILATION SO AS TO PREVENT NOXIOUS EXHAUST GASES FROM
ACCUMULATING.
CAUTION
DO NOT USE GASOLINE, SOLVENTS OR OTHER FLAMMABLE LIQUIDS AS
DETERGENTS.
CAUTION
USE COMMERCIAL NON-FLAMMABLE AND NON-TOXIC SOLVENTS.
CAUTION
DO NOT USE COMPRESSED AIR OR WATER AT HIGH PRESSURE TO
MACHINE. IF THIS IS UNAVOIDABLE, THEN WEAR GOGGLES
PROTECTION AND LIMIT THE PRESSURE AS MUCH AS POSSIBLE.
WORK IS FINISHED, AND WITH THE MACHINE DISCONNECTED
TRACTOR, INSPECT AND CHECK THE MACHINE COMPLETELY.
CLEAN THE
WITH SIDE
WHEN THE
FROM THE
The following should be noted if the machine is scrapped:
The machine consists mainly of ferrous material which must be disposed of according to the regulations in
force in the country concerned.
There is also a small amount of plastic which must be disposed of according to the regulations in force in the
country concerned.
HR-05
© 2014 Ranch Rite
Maintenance Section 5-2