Download PSIM User Manual

Transcript
Introduction
Chapter 1: General Information
1.1
Introduction
PSIM is a simulation package specifically designed for power electronics and motor control. With fast simulation, friendly user interface and waveform processing, PSIM provides a powerful simulation environment for power converter analysis, control loop
design, and motor drive system studies.
This manual covers both PSIM * and its add-on Motor Drive Module and Digital Control
Module. The Motor Drive Module has built-in machine models and mechanical load models for drive system studies. The Digital Control Module provides discrete elements such
as zero-order hold, z-domain transfer function blocks, quantization blocks, digital filters,
for digital control analysis.
The PSIM simulation package consists of three programs: circuit schematic editor SIMCAD*, PSIM simulator, and waveform processing program SIMVIEW *. The simulation
environment is illustrated as follows.
SIMCAD
PSIM
SIMVIEW
Circuit Schematic Editor (input: *.sch)
PSIM Simulator (input: *.cct; output: *.txt)
Waveform Processor (input: *.txt)
Chapter 1 of this manual describes the circuit structure, software/hardware requirement,
and installation procedure. Chapter 2 through 4 describe the power and control circuit
components. The use of SIMCAD and SIMVIEW is discussed in Chapter 5 and 6. Error/
warning messages are listed in Chapter 7. Finally, sample examples are provided in
Appendix A, and a list of the PSIM elements is given in Appendix B.
1.2
Circuit Structure
A circuit is represented in PSIM in four blocks: power circuit, control circuit, sensors, and
switch controllers. The figure below shows the relationship between these blocks.
*. PSIM, SIMCAD, and SIMVIEW are copyright by Powersim Inc., 2001
PSIM User Manual
1-1