Download PSIM User Manual
Transcript
Introduction Chapter 1: General Information 1.1 Introduction PSIM is a simulation package specifically designed for power electronics and motor control. With fast simulation, friendly user interface and waveform processing, PSIM provides a powerful simulation environment for power converter analysis, control loop design, and motor drive system studies. This manual covers both PSIM * and its add-on Motor Drive Module and Digital Control Module. The Motor Drive Module has built-in machine models and mechanical load models for drive system studies. The Digital Control Module provides discrete elements such as zero-order hold, z-domain transfer function blocks, quantization blocks, digital filters, for digital control analysis. The PSIM simulation package consists of three programs: circuit schematic editor SIMCAD*, PSIM simulator, and waveform processing program SIMVIEW *. The simulation environment is illustrated as follows. SIMCAD PSIM SIMVIEW Circuit Schematic Editor (input: *.sch) PSIM Simulator (input: *.cct; output: *.txt) Waveform Processor (input: *.txt) Chapter 1 of this manual describes the circuit structure, software/hardware requirement, and installation procedure. Chapter 2 through 4 describe the power and control circuit components. The use of SIMCAD and SIMVIEW is discussed in Chapter 5 and 6. Error/ warning messages are listed in Chapter 7. Finally, sample examples are provided in Appendix A, and a list of the PSIM elements is given in Appendix B. 1.2 Circuit Structure A circuit is represented in PSIM in four blocks: power circuit, control circuit, sensors, and switch controllers. The figure below shows the relationship between these blocks. *. PSIM, SIMCAD, and SIMVIEW are copyright by Powersim Inc., 2001 PSIM User Manual 1-1