Download User Manual - MLT Inverters

The Load Line Summary screen shows the Load Voltage, Current, Real and Apparent Power
Consumed.
L1, L2 or L3 abbreviates “Line 1, 2 or 3” and refers to the parameters associated with the AC
line or module connected to the system. A 12 KVA inverter system for example would have 2
x 6 KVA modules and would display the rows L1 and L2 that refer to the 1st and 2nd inverter
module stacked underneath the controller box. For 3 phase systems phases are labelled L1 to
L3 and each inverter module gets assigned a separate phase.
3.4 Source Line Summary
LOAD LINE 1: SINGLE OR RED PHASE LOAD DATA:
VOLTAGE, CURRENT, REAL POWER, REAL + REACTIVE POWER
SCREEN
NUMBER
4
5 0 . 0
L 1 :
2 3 0
L 2 :
0 0 3
L 3 :
0 0 0
H z
V
V
V
S O
0
0
0
U
1
0
0
R
2
0
0
C E
A
A
A
L I
0
0
0
N
0
0
0
E
S U
3 . 0 k
0 . 0 k
0 . 0 k
SOURCES ON LINE:
A, B OR I (INVERTER)
M M A R Y
G
w
0 0 3
w
0 0 0
w
0 0 0
o
.
.
.
o
0
0
0
d
( A - I )
k V A
k V A
k V A
YELLOW & BLUE PHASE SOURCE LINES
NOT DISPLAYED IN SINGLE PHASE SYSTEMS
Figure 9: Screen 4 – Source Line Summary
The Source Line Summary screen shows the Load Voltage, Current, Real and Apparent Power
Consumed.
3.5 Source Status Screen
SCREEN
NUMBER
CURRENT
TIME
ROW 2:
SOURCE STATE
DATE
SOURCES ON LINE:
A, B OR I (INVERTER)
S O U R C E S T A T U S 0 9 – 0 3 – 0 9 ( A - I )
5
0 9 : 3 1 : 2 7
A – R u n n i n g
M o d e :
B – S t o p p e d
A – B a t t e r y C h a r g i n g
B – C a n S t o p
L o w :
S t a t u s: A – S r c
I n
S p e c
B – S r c
S r c
H z
L o w
ROW 3:
SOURCE CURRENT OPERATION
ROW 4:
SOURCE OUTPUT STATUS
Figure 10: Screen 5 – Source Status
NOTES: If a Source is disabled, the data for that Source will not be displayed.
To disable a Source, set MENU  SYSTEM CONFIG/SETUP  SYSTEM
SETUP  SOURCE  SP16 (Source A) or SP17 (Source B) to NONE.
Row 2: Typical Source States are Running, Stopped, Cooling Down, etc.
PAGE 40
POWERSTAR USER MANUAL